24.Check all guards for proper operation before each use. Never disable guards. Do not operate the Table Saw if the guard assembly does not move freely and close instantly. Before each use, raise the guard assembly and make sure it moves freely and does not touch the Saw Blade or any other part, in all angles and depths of cut.
25.Never perform layout, assembly, or setup work on the Table of the Table Saw when the machine is running.
26.Make sure to remove all adjusting wrenches from the Table Saw before turning it on.
27.Use a “push stick” or “auxiliary handle” (neither included) only when ripping widths of 2” to 6”. Use a “push block” and “auxiliary fence” (neither included) when ripping widths under 2”.
28.Keep the Table of the Table Saw clean and clear of debris. Remove
DRILL PRESS SAFETY RULES
1.Avoid unintentional starting. Make sure you are prepared to begin work before turning on the Drill Press.
2.Do not force the Drill Press. This tool will do the work better and safer at the speed and capacity for which it was designed.
3.
WARNING! Keep hands and fingers safety away from the cutting area.
4.Never leave the Drill Press unattended when it is plugged into an electrical outlet. Turn off the tool, and unplug it from its electrical outlet before leaving.
5.Make sure the Table of the Drill Press and surrounding area are clear with the exception of the workpiece to be drilled.
6.Before using the Drill Press, check to make sure the bit is properly mounted in the Chuck. Make sure the Bit is sharp, and is not cracked or bent.
7.Never attempt to drill more than one workpiece at a time.
8.Never attempt to drill freehand. Make sure the workpiece to be drilled is secured in a vise or is clamped to the table.
SKU 96067 | For technical questions, please call | Page 11 |