TO INSTALL THE DISC SANDER
1.Insert the Sanding Disc Arbor into the Collet, and insert the Collet into the Quill. Then tighten the Drawrod. Move the saw Table to about 1/16” from the sanding surface. Adjust the height of the Table to about 1” below the centerline of the Disc Sander. (See Figure O and Assy. Diagram, page 53.)
2.NOTE: If your workpiece requires beveled sanding, tilt the Table to the desired angle. Then adjust the Table’s inside edge height so that it is still about 1” below the centerline of the Disc Sander. (See Figure O and Assy. Diagram, page 53.)
FIGURE O
TO SET UP THE VERTICAL DRILL PRESS
1.Mount the saw Table and tilt it 90 degrees. Move the Powerhead and Carriage into the approximate positions you will need for the drilling task at hand. Then lock the Powerhead and Carriage in place.
(See Figure P, next page.)
2.Loosen the two Locking Knobs on the Powerhead Support Bracket. Lift the machine into the vertical Drill Press position. Firmly tighten the Vertical Locking Knob on the Tailstock Support Bracket.
(See Figure P, next page.)
3.Remove the saw blade table Insert and install the drill Insert. Adjust the Powerhead and/or Carriage to the exact position you need. Then, make sure to retighten all Locking Knobs. (See Figure P, next page.)
4.CAUTION! When moving the Powerhead or Carriage while the machine is in the vertical position, make sure to hold the Travel Knob while loosening the Locking
SKU 96067 | For technical questions, please call | Page 28 |