Harbor Freight Tools 96067 Power KEY, To Move the Powerhead, To Move the Quill Feed

THE POWER KEY

The Power Key is used to turn the Metal/Woodworking Machine on and off. Always keep the Power Key out of reach of children and other unauthorized people. Before turning the Key to its “ON” position, make sure the Variable Speed Control Dial is set at its lowest setting. (See page 16 and 17.)

TO MOVE THE POWERHEAD

To slide the Powerhead on the way tubes loosen the two Lock Knobs. Then crank the Travel Hand Wheel. The Powerhead and Carriage travel on Way Tubes. The Way Tubes allow for more precise movement of the Powerhead in horizontal or vertical positions. Always retighten both Lock Knobs after positioning the Powerhead. (See page 16 and 27.)

TO MOVE THE QUILL FEED

The Quill Feed Handles located on the front and back of the Powerhead extend 5” from the Quill. Behind the front Quill Feed Handle is the Quill Feed Lock. Make sure to engage the Lock once the Quill has been extended.

TO ADJUST SPEED BELTS AND PULLEYS

1.The Powerhead features a lower and upper Pulley located under the Pulley Cover. A decal on top of the Pulley Cover refers to the V-Belt location on the

Upper Pulley. The V-Belt for all three Pulley configurations must be straight.

Never attempt to cross a Lower Pulley with one that is not directly above it. The decal illustrates pulley selection to corresponding RPM:

a.Position #1 = 32 to 900 RPM

b.Position #2 = 1200 to 3600 RPM

c.Position #3 = 4000 to 7200 RPM

2.To change speeds with different Pulley positions:

a.Loosen the Pulley Cover Lock on the back of the Woodworking Machine.

b.Slide the Pulley Cover away from the Powerhead.

c.Lift the Belt Tension Lock Lever up.

d.Lift the Motor Mount Bracket up to release tension on the V-Belts.

e.While slowly rotating the Upper Pulley, pull the V-Belt off its Pulley.

f.Reposition the V-Belt on the new, matched, Pulley setting.

g.Push the Motor Mount Bracket down to tighten the V-Belt tension. Then push the Belt Tension Lock Lever down to keep the desired tension on the V-Belt.

h.Set the Pulley Cover back in place and tighten the Cover Lock. (See page 16.)

SKU 96067 For technical questions, please call 1-800-444-3353. Page 19