4.Place the pencil back in the Miter Gauge and align the pencil point and the high spot together at the infeed end of the Table. Rotate the Saw Blade, and bring the Miter Gauge and the high spot together at the outfeed of the Table.
5.The Extension Table is aligned if the pencil tip touches the Saw Blade just the same touch and place. Make sure all four Hex Head Capscrews attaching the Table are tight.
6.The Extension Table is not aligned if the pencil tip pushes the Saw Blade or there is a gap between the pencil tip and Blade. If the Table is not aligned, loosen all four Capscrews attaching the Table. Once alignment is achieved, tighten all four Capscrews.
7.The Extension Table will now be aligned each time you mount it in the
TO SET THE CARRIAGE BUMPER BOLT
1.With the Saw Blade mounted and the Quill fully retracted, bring the Powerhead and Carriage together until they touch.
2.Install the saw Table on the Carriage.
3.Lower the Table, and look down through the Saw Blade Insert and move the Carriage left or right as needed to center the Blade in the Saw Insert Slot.
4.Once the Table is centered over the Saw Blade, lock the Powerhead and Carriage onto the Way Tubes.
5.Adjust the Carriage Bumper Bolt on the Carriage so that it just touches the side of the Powerhead. Then tighten the Locking Nut against the Carriage Casing.
6.Now each time the Table Saw is set up, the Saw Blade will be centered in the saw Table Insert Slot.
TO ALIGN THE SAW TABLE 90 DEGREES TO THE POWERHEAD
1.Move the Powerhead about 10” from the Carriage.
2.Install the saw Table and Drill Chuck/Drill Bit in the Horizontal Boring Tool.
3.Loosen the Table Trunnion Locks. Then tilt the Table 90 degrees and tighten the Locks.
4.Place a
SKU 96067 | For technical questions, please call | Page 36 |