9.When drilling a large workpiece, make sure its entire length is properly supported. If necessary, use a roller stand (not included).
10.Keep all guards in place, in proper adjustment, and in proper alignment.
11.Do not use rotary planers, wire wheels, or router bits on the Drill Press.
12.Always feed the workpiece into and against the rotational direction of a bit or cutter.
13.When drilling softer materials or small holes, use the higher speed settings. When drilling harder materials or holes, use the slower speed settings.
14.Allow the bit to spin up to full speed before feeding it into a workpiece. When turning off the Drill Press, allow the bit to spin down and stop on its own. Do not press against the bit to stop it.
15.The bit will become hot while drilling. Allow the bit to completely cool before handling.
16.Do not force the bit into the workpiece when drilling. Apply moderate pressure, allowing the bit to cut without being forced.
17.Turn off the Drill Press and allow the machine to completely stop if the bit is to be backed out of an uncompleted cut.
18.Never attempt to remove material stuck in the moving parts of the Drill Press while it is plugged in and running.
LATHE SAFETY RULES
1.Make sure all adusting wrenches are removed from the Lathe prior to turning on the machine.
2.Keep all safety guards in proper working order, proper adjustment, and proper alignment.
3.Make sure the workpiece is securely mounted in the Lathe before turning on the machine. A loose workpiece can fly off the Lathe, causing severe personal injury and/or property damage.
4.Always keep hands and fingers as far away as possible from the moving parts of the Lathe. Do not reach over or across the Lathe when it is running.
SKU 96067 | For technical questions, please call | Page 12 |