HORIZONTAL BORING SAFETY RULES
1.Avoid unintentional starting. Make sure you are prepared to begin work before turning on the Router/Shaper.
2.Never leave the Router/Shaper unattended when it is running. Turn off the Router/Shaper before leaving the work area.
3.Always place scrap wood behind the workpiece to prevent damage to the drill bit and to avoid splintering.
4.Always firmly support and guide the wood before and during drilling.
5.Use only the speeds listed in the Speed Chart.
6.Make sure the bit never touches the Table, Rip Fence, or Miter Gauge.
7.Keep your body away from the drill bit when it is exposed and rotating.
8.Keep all safety guards in place and in proper working order.
9.Make sure the workpiece is free from nails and any other foreign object which could break or otherwise damage the drill bit.
10.Never start the the machine under a load. Allow the machine to reach full speed before feeding a drill bit into the workpiece.
DISC SANDER SAFETY RULES
1.Always stand on the left of the Sanding Disc’s center. Never stand on the right side of center.
2.Keep hands and fingers away from the Sanding Disc and the nearest edge of the Table.
3.Use only the speeds listed in the Speed Chart.
4.Hold the workpiece firmly when feeding it into the Sanding Disc.
5.Use only enough pressure to touch the workpiece lightly against the Sandpaper on the Disc.
6.Before sanding, turn on the Disc Sander and check for excessively loose Sanding Disc.
7.Allow the Sanding Disc to spin up to full speed before feeding a workpiece into it. Do not ever feed a workpiece past the center line of the disc. When turning off the Disc Sander, allow the Sanding Disc to slow down and stop on its own. Do not press against the Sanding Disc to stop it.
SKU 96067 | For technical questions, please call | Page 14 |