ASSEMBLY INSTRUCTIONS
TO ATTACH THE SHELF TO THE STAND
NOTE: Always wear ANSI approved safety goggles and work gloves during assembly.
NOTE: The assembly procedures will require the help of additional manpower and a proper lifting device.
1.Set the Stand
(See Figure E.)
2.Slide the Shelf between the Stand Legs, making sure the holes in the middle of the Shelf face the rear of the Stand. (The slot in each Stand end is located toward the front.) (See Figure E and Assy. Diagram, page 37.)
3.Align each Bolt hole in the ends and back of the Shelf with the hole located in the middle of each end of the Cabinet.
(See Figure E and Assy. Diagram, page 37.)
4.Insert a Screw through each hole, and secure with a Washer and a Nut.
(See Figure E and Assy. Diagram, page 37.)
FIGURE E
TO INSTALL THE CASTERS
1.Position the left Caster with its Foot Wheel (109), used to raise the Stand, oriented outward from the Cabinet. Then secure the Caster to the Cabinet, using the Hex Head Screws.
(See Figure F, next page and Assy. Diagram, page 37.)
2.Position the right Caster with its foot lever oriented outward from the Cabinet. Then secure the Caster to the Cabinet, using the Hex Head Screws.
(See Figure F, next page and Assy. Diagram, page 37.)
3.Place the Stand into the upright position.
SKU 96067 | For technical questions, please call | Page 21 |