4-11. Installing Drive Rolls
1
4
2
3
1Drive Roll Carrier
2Ejector Button
3Drive Roll
4Pressure Door Assembly
Installation
Open pressure door assembly. Lift drive roll swing arm.
Align drive roll slots with three lobes on drive roll carrier.
Insert drive roll onto carrier. Drive roll will snap into place.
When closing swing arm, push firm- ly into position.
Swing arm has built in resistance to prevent swing arm from closing abruptly.
.When using cored welding wire use knurled drive rolls.
Removal
.Remove PD wire guide before removing lower drive rolls.
Lift up drive roll swing arm and press ejector button in middle of drive roll carrier.
804
Notes