Sanyo UHX1852 Indicator when swing operation is stopped, Timer SET button, OFF Timer, On Timer

Remote Control Functions

2. Wireless Remote Controller

1

1

2

2

3

3

4

4

5

5

6

6

7

7

8

8

Indicator when swing operation is stopped

Fan and heating Cooling and drying

			During cooling and drying, the flap does not stop at the downward position.
			Even if the flap is stopped at the downward position during the swing operation, it does not
			stop until it moves to the third position from the top.
	NOTE	This function is available only for models X, A, T and K.
J: TIMER SET button			Use this button while the unit is operating to switch between timer settings.
(OFF Timer)				: The air conditioner stops after a preset time elapses.
(OFF Cycle Timer)				: The air conditioner always stops after a preset time elapses.
(ON Timer)				: The air conditioner starts after a preset time elapses.
K: Time setting buttons			: Press this button to increase the time.
			: Press this button to decrease the time.
L: SET button			Use this button to set the timer.
M: CL button			Use this button to clear the timer setting.
N: VENTILATION button			This is used when a ventilation fan (available commercially) is connected. Pressing the
			VENTILATION button turns the fan on and off. The ventilation fan also turns on and off when
			the air conditioner unit is turned on and off. (The display of the remote control unit shows
			" " while the ventilation fan is running.)

*If the VENTILATION button is held down for 4 or more seconds when the batteries have been replaced, "" appears on the display, and the ventilation fan can be used.

O:Remote control sensor This detects the temperature around the remote control unit when the remote control unit position has been selected using the sensor button.

P:ACL button (ALL CLEAR) Puts the wireless remote control unit into pre-operation status. This is used after the batter- ies have been replaced or when the slide switch setting has been changed.

Q: Slide switch	This switch is for setting the operation mode of the indoor unit and setting the flaps.
			The wireless remote control unit sends the temperature signal to the air
		NOTE
			conditioner regularly at five-minute intervals. If the signal from the wireless
			remote control unit stops for more than ten minutes due to the loss of the
			wireless remote control unit or other trouble, the air conditioner will switch to
			the temperature sensor which is built into the indoor unit and control the room
			temperature. In these cases, the temperature around the wireless remote
			control unit may differ from the temperature detected at the air conditioner's
			position.
			When low fan speed is selected and the air conditioner is in cooling opera-
			tion at a low outdoor temperature of less than 50°F (10°C), the air conditioner
			may automatically switch to medium fan speed to prevent freezing.

2-6