Sanyo KHX1852, UHX2452 Group Control Using 2 Remote Controllers, Remote Controller Setting Mode

CODE No. (New) (Old)

ITEM

Vent. button

Temperature unit

Remote Control Functions

3. Timer Remote Controller (RCS-TM80BG)

Use AWG#20 to AWG#16 wires.

Remote controller wiring can be extended to a maximum of 1640 ft.

(1)Strip the insulation to approximately 35/64" from the ends of the wires that will be connected.

(2)Twist together the 2 wires and create a crimp connection at the wire joint.

(3)If a special crimping tool is not used, or if the connection is soldered, insulate the wires using insulation tape.

5. Group Control Using 2 Remote Controllers

It does not matter which of the 2 remote controllers you set as the main controller. When using multiple remote controllers (up to 2 can be used), one serves as the main remote controller and the other as the sub-remote controller.

Provided wire joint (white)

Remote controller wiring

Power wire from remote controller unit

Fig. 2-2

Remote controller

(main)(sub)

				Connection wiring 1 2
		1	2
				for group control
2P terminal
base for remote
control wiring
		1	2			1	2		1	2
	Indoor unit				Indoor unit			Indoor unit
		No. 1				No. 2			No. 3

Wire joint

1 2

Indoor unit

No. 8

: Ground (earth)

Fig. 2-3

6. Remote Controller Setting Mode

To set the remote controller main/sub setting or change the sensor, follow the steps below.
Press both		and	buttons on the remote controller for more than
4 seconds together.
Select CODE No. with			buttons.	CODE	ITEM		DATA
				ITEM
Change DATA with			(TIMER) buttons.
					RCU. Main/Sub	Sub	Main
Press	. Finally, press		.
					Clock display	24 hours	12 hours (AM/PM)
* DATA is memorized in the RCU. (DATA setting will not be changed even
					RCU. CK	RCU. CK	Normal
when the power is turned off.)					Room temperature sensor	Main unit	RCU

*Make sure to set [Normal] for RCU. CK.

7.Indoor Unit Setting Mode

1

1

2

2

3

3

To select the ventilation setting or change the temperature unit, follow the steps below.

Press	+	+	buttons on the remote controller for more than 4 sec-
onds together.					CODE
Select CODE No. with				buttons.
					ITEM
Change DATA with				(TIMER) buttons.
Press	. Finally, press			.

*DATA is memorized in the indoor unit. (DATA setting will not be changed even when the power is turned off.)

	DATA
No		Yes
oC		oF

4

4

8. To Display the Sensor Temperature:

Press both and buttons on the remote controller for more than 4 seconds together.

Change the sensor address (CODE No.) with buttons.

Select the UNIT No. which you want to call with the button. Press the button to fi nish service mode.

9. To Display the Trouble History:

Press both and buttons on the remote controller for more than 4 seconds together.

Change the alarm message: buttons Press the button to fi nish service mode.

2-19

5

5

6

6

7

7

8

8