Sanyo UHX1252, UHX2452, UHX0752, UHX3652, UHX1852 „ Setting mode, Parameter Description SET Data

Service Checker

1. Outdoor Unit Maintenance Remote Controller

1

1

2

2

3

3

„Setting mode 2

Press the	(CHECK) button,	(SET)
button and the	(CANCEL) button simultane-
ously for 4 seconds or longer.		4

Press the temperature setting and buttons to change the item code. The item codes and setting data are shown in the table below.

Press the timer time and buttons to change the setting data.

To confirm the changed setting data, press the (SET) button.

(At this time, the SET DATA display stops blinking and remains lit.)

“” blinks when this mode is engaged, and when this mode is engaged, “Now Setting” is dis- played blinking, and the address of the outdoor unit that is being set “System XX-YY” (System XX

=System address, YY = Outdoor unit address), the item code No. (values from the table below), and the corresponding settings data (6 digits) are displayed. The item code number (values shown in the table below) and the corresponding setting data (6 digits) are also displayed. (The 6 digits of the setting data are displayed by changing between the first 3 digits (Fig. (C)) and the last three digits (Fig. (D)). When the first 3 digits are displayed, the top dot of the colon is illuminated.)

To exit setting mode, press the (CHECK) button. Returns to normal display mode.

5 1 3 2

(C) Display of first 3 digits

4

4

5

5

6

6

7

7

8

8

(D) Display of last 3 digits

Refrigerant type: (C) and (D) are displayed alternately.

The example here (000, 410) indicates R410A.

CODE	Parameter		Description (SET DATA)
NO.
	Outdoor unit capacity	0 = Disabled	112 (36 Type) 160 (60 Type)
		280 (90 Type)	450 (140 Type)
			6-10