Sanyo THX2452, UHX2452, UHX0752, UHX1252, UHX3652, UHX1852, THX1252, THX1852, XHX1852, XHX3652 Receiver

Remote Control Functions

2. Wireless Remote Controller

2. Receiver

The signal receivers with the exception of the separately installed signal receiver are mounted on the indoor units.

X type T type

Separately installed signal receiver

(A, U, D type)

K type

1

1

A: Receiver		This section picks up infrared signals from the wireless remote control unit (transmitter).
Indication lamps		One of these lamps will blink when trouble has occurred. When an indicator lamp starts to
		blink, refer to “Troubleshooting” on page 2-14.
	B: Operation lamp	This lamp lights when the appliance is turned on.
	C: Timer lamp	This lamp lights when the system is being controlled by the timer.
	D: Standby lamp	• This lamp lights at the following times during heating operations:
		When operation has started, when the thermostat has been activated, during a defrosting
		operation.
		• The lamp blinks when trouble has occurred.
E: Emergency operation		This is used when operation cannot be performed due to trouble with or loss of the wireless
	button	remote control unit.
F: ADDRESS switch		This switch is used in order to prevent the sending of signals to the wrong indoor unit when
		a multiple number of indoor units that can be operated by the wireless remote control units
		have been installed in the same room.
G: SWING button		When this button is pressed, the airflow sweeps up and down automatically.
H: FILTER lamp		This lamp lights to indicate that it is time to clean the filter.

•If two beeps are heard, the operation lamp among the indication lamps has lighted and the timer lamp and standby lamp blink alternately. In cases where heat pump models are used, this indicates a cooling/heating mode mismatch and, as such, operation in the desired mode cannot be performed. (The same beeps will be heard and the same operation lamps will light when auto cooling/heating has been selected on a model which does not have the auto cooling/heating function.)

•When local operation has been set to disable because the centralized control mode is established, for instance, pressing the ON/OFF operation button, MODE button or temperature setting buttons results in the sounding of five beeps, and the attempted change in the operation will not be accepted.

2-7

2

2

3

3

4

4

5

5

6

6

7

7

8

8