![](/images/new-backgrounds/1209936/209936123x1.webp)
unexpectedly when power is reconnected to the tool. Hold the side handle and rear handle firmly to maintain control of tool at start up and during use.
Sanding Flap Discs
TRIGGER OPERATION
To turn the tool on, depress
FIG. 6 |
| C |
B A
Type 27 guard | Type 27 guard |
D284937 7" (180 mm) | D284937 7" (180 mm) |
D284939 9" (230 mm) | D284939 9" (230 mm) |
English
TRIGGER OPERATION WITH LOCK-ON FEATURE
To turn tool on, depress trigger. Depress and hold
To turn the tool off, depress and release trigger. The lock pin button will pop out, permitting the trigger to disengage and causing the tool to turn off.
NOTE: Allow the tool to reach full speed before touching tool to work surface. Lift the tool from the work surface before turning the tool off.
CAUTION: Make sure the wheel has come to a complete stop before setting the tool down.
SPINDLE LOCK BUTTON (FIG. 7) | FIG. 7 | ||
The spindle lock button (D) is provided to |
|
|
|
prevent the spindle from rotating when |
|
|
|
installing or removing wheels. |
|
|
|
NOTICE: To reduce the risk of damage to |
|
|
|
the tool, do not engage the spindle lock |
|
|
|
button while the tool is operating. Damage |
|
|
|
to the tool will result and attached accessory |
|
| D |
may spin off possibly resulting in injury. |
|
|
To engage the lock, depress the spindle lock button (D) and rotate the spindle until you are unable to rotate the spindle further.
hubbed sanding flap | backing flange |
disc |
|
| |
| flap disc |
| clamp nut |
|
NOTE: Wheel size must match guard size; i.e., a new 7" (180 mm) wheel may not be used with a 9" (230 mm) guard. The bottom surface of wheel must be inside the bend of the guard lip.
62