Appendix A Repackaging the Router
Repackaging the Routers
REVIEW DRAFT — CISCO CONFIDENTIAL
Completing the Repackaging
To repackage the router, use Figure A-1 on page A-4as a reference and follow these steps:
Step 1 Verify that the anchor clips fastening the chassis to the scissor-jack platform are installed correctly and that the bolts are tight.
Step 2 Verify that the bolts fastening the hold-down brackets to the sides of the scissor-jack platform and the top of the pallet are tight.
Step 3 Pull the plastic bag over the router to protect it against electrostatic discharge (ESD) and dust.
Step 4 Place the side of the accessories package with the single box containing the center-mount rack-mounting brackets against the back panel of the router on the extended deck of the pallet body.
Step 5 Place the folded corrugated spacer on top of the accessories package, then place the two foam inserts around the top of the router.
Step 6 To install the U-shaped, corrugated side panels, use Figure A-1 on page A-4as a reference and follow these steps:
a.Set the long side of one panel on the pallet base such that it sits inside the bead-boards attached to the outside corners of the pallet riser blocks and against the side of the pallet platform.
b.Set the narrow end flaps of the panel inside the bead-boards attached to the outside corners of the pallet riser blocks.
c.Position the opposite U-shaped side panel such that one narrow end flap is inside the narrow end flap of the first U-shaped side panel, while the other narrow end flap is outside the narrow end flap of the first U-shaped side panel.
Note Because the two U-shaped side panels are identical, interlocking them in this fashion maintains the correct overall container dimensions and strength.
| | Cisco XR 12416 Router Chassis Installation Guide | | |
| | |
| OL-xxxxx-xx | | | A-23 |
| | |
