Appendix A Repackaging the Router
Repackaging the Routers
REVIEW DRAFT — CISCO CONFIDENTIAL
If your router is equipped with the DC-input power shelf, disconnect the eight source DC positive and negative power cables and the single ground cable from the terminal studs on the back panel of the power shelf as instructed in the “Removing and Installing a DC-Input Power Shelf” section on page 5-54.
Removing Components from the Chassis to Reduce Weight
A fully-equipped router can weigh as much as 415 lb (188 kg). To reduce the top-end weight of the chassis and lower the center of gravity, which might make the chassis more stable as you move it, you may choose to remove some of the components from the chassis.
Procedures in the following sections describe the steps for removing some of the router components:
•Removing Power Modules, page A-9
•Removing the Blower Modules, page A-10
•Removing the Cards from the Chassis Card Cages, page A-10
Removing Power Modules
Each AC-input power supply weighs 12.7 lb (5.7 kg). By electing to remove the three power supplies from the standard AC-input power shelf, you reduce the top-end weight of the chassis by approximately 38.1 lb (17.1 kg). By electing to remove the four power supplies from the optional AC-input power shelf, you reduce the top-end weight of the chassis by approximately 50.8 lb (22.8kg) Remove the AC-input power supplies as described in the “Installing AC-Input Power Supplies” section on page 3-75.
Each DC-input power entry module weighs 6.4 lb (2.9 kg). By electing to remove the four power entry modules from the power shelf, you reduce the top-end weight of the chassis by approximately 25.6 lb (11.6 kg). Remove the DC-input power entry modules as described in the“Removing DC-Input PEMs” section on page 3-12.
| | Cisco XR 12416 Router Chassis Installation Guide | | |
| | |
| OL-xxxxx-xx | | | A-9 |
| | |
