14.5 Making Tenons
Tenons and grooves in end grain must only be made with the workpiece firmly held and guided by the sliding carriage TF 100, available as optional accessory.
To complete the tenon, turn work- piece over by 180° and make another pass.
Place workpiece on the sliding carria- ge's table and secure with the clam- ping arm. Lower the holddown shoe as much as possible to cover the space between the fence plates above the tool.
Start machine. Feed work slowly and with a steady motion against the rota- ting tool. When the pass is completed pull the sliding carriage back to its starting position.
14.5 Set-In Work
Install table extension according to Set the backstop as required. the instructions provided. Set tool,
fence and guard as required.
15 Care And Maintenance
Always disconnect from power before servicing.
Danger of severe personal injury if machine is started unintentionally.
-Lubricate all moving parts regularly with a few drops of motor oil.
-Clean table and fence plates regularly, keep
Start machine. Place workpiece on the table and against the backstop, then push forward against the fence into the rotating tool.