Introduction / General safety advice for electrical power tools
QTechnical Data
X3.6-LI A cordless screwdriver:
Rated voltage: | 3.6 V |
|
|
| |||
Rechargeable battery |
|
|
|
(integrated): | LITHIUM | ||
Rechargeable battery |
|
|
|
capacity: | 1350 mAh | ||
n0 200 | |||
Torque: | max. 4 Nm | ||
Tool holder: | 6.35 mm (1/4“) | ||
Input: |
|
|
|
Rated voltage: | |||
Rated power: | 5,5 W | ||
Output: |
|
|
|
Rated voltage: | 6,2 V |
|
|
| |||
Rated power: | 400 mA | ||
Charging time: | Approx. 3 hrs. | ||
Protection class: | II / | ||
Noise / vibration data:
Values determined in accordance with EN 60745 The sound pressure level
The sound level while working can exceed 80 dB (A).
Total vibration (vector sum of three directions) is calculated in accordance with EN 60745:
Screwing: Vibration emission value
ah,D = 2.101 m / s2, uncertainty K = 1.5 m / s2
Warning! The vibration level given in these instructions has been measured in accordance with a standardised measurement procedure specified in EN 60745 and can be used to compare devices. Different uses of the device give rise to different vibration levels and in many cases they may exceed the values given in these instructions. It is easy to underestimate the vibration load if the electrical power tool is used regularly in particular circumstances.
Note: If you wish to make an accurate assessment of the vibration loads experienced during a particular period of working, you should also take into account the intervening periods of time when the device is switched off or is running but is not actually in use. This can result in a much lower vibration load over the whole of the period of working.
General safety advice for electrical power tools
Warning! Read all the safety advice and instructions! Failure to observe the safety advice and instructions may result in electric shock, fire and / or serious injury.
KEEP ALL THE SAFETY ADVICE AND INSTRUC- TIONS IN A SAFE PLACE FOR FUTURE REFER- ENCE! THE TERM “ELECTRICAL TOOL” USED IN THE SAFETY ADVICE REFERS TO ELECTRICAL TOOLS POWERED BY MAINS ELECTRICITY (BY MEANS OF A MAINS LEAD) AND ELECTRICAL TOOLS POWERED BY RECHARGEABLE BATTER- IES (WITHOUT A MAINS LEAD).
1. Workplace safety
a)Keep your working area clean and well lit. Untidy or poorly lit working areas can lead to accidents.
b)Do not work with the device in potentially explosive envi- ronments in which there
are inflammable liquids, gases or dusts. Electrical power tools create sparks, which can ignite dusts or fumes.
c)Keep children and other peo-
ple away while you are op- erating the electrical tool.
Distractions can cause you to lose control of the device.
GB
7