GE EPM 6000 instruction manual Configuring the Communication Port Setting

CHAPTER 4: USING THE METER

ZPush the DOWN Button to scroll through the configuration mode parameters.

ZPress ENTER when Cnct is the active parameter (i.e. it is in the “A” screen and flashing).

This will display the Cnct (connection) screen. The possible connection configurations are 3-element Wye (3 EL WYE), 2.5-element Wye (2.5EL WYE), and 2 CT Delta (2 Ct deL), as shown below.

3-Element Wye 2.5-Element Wye 2 CT Delta

ZPress ENTER to scroll through the other CFG parameters.

ZPress DOWN or RIGHT to display the password screen (see Reset Mode and Password Entry on page 4–6 for details).

ZPress MENU to return to the main configuration menu.

4.3.7Configuring the Communication Port Setting

Use the following procedure to program the communication port (POrt) settings.

ZPush the DOWN Button to scroll through the configuration mode parameters.

ZPress ENTER when POrt is the active parameter (i.e. it is in the “A” screen and flashing).

The following parameters can be configured through the POrt menu

•The meter address (Adr, a 3-digit number).

•The baud rate (bAUd). Select from “9600”, “19.2”, “38.4”, and “57.6” for 9600, 19200, 38400, and 57600 kbps, respectively.

•The communications protocol (Prot).

4–14 EPM 6000 MULTI-FUNCTION POWER METERING SYSTEM – USER GUIDE