Hitachi W 6VB2 Confirm the direction of bit rotation Fig, Adjusting the tightening depth Fig

English

6.Confirm the direction of bit rotation (Fig. 2)

The bit rotates clockwise (viewed from the rear side) when the reversing switch lever is set to the “R” side posi- tion. When the lever is set to the “L” side position, the bit rotates counter- clockwise and can be used to loosen and retract screws.

CAUTION:

Never change the bit rotating direction while operating the Screw Driver. Turn the main switch off before changing the rotating direction, otherwise, burn- ing of the motor will result.

7.Adjusting the tightening depth (Fig. 3)

Pull the lock sleeve in the direction of arrow to remove it from the spline in- stalled in the gear cover.

While pulling the lock sleeve and turn- ing it right and left, adjust the position of locator. Push the lock sleeve and aligen the gear cover spline with the lock sleeve spline.

The lock sleeve is inserted onto the gear

cover spline and locked.

(1)For hex-head screws (Fig. 4)

Mount a hex-head screw on the hex- socket and set the distance between the sub-stopper end and the screw head bottom to 0.04” – 0.06” (1 – 1.5 mm).

(2)For drywall screws (Fig. 5)

Mount a drywall screw on the bit, and set the distance between the sub-stop- per end and the screw head to 0.07” – 0.10” (2 – 2.5 mm).

(3)For plus-head self-drilling screws (Fig. 6)

Mount a self-drilling screw on the bit, and set the distance between the sub- stopper end and the screw head bot- tom to 0.04” – 0.06” (1 – 1.5 mm).

R side

Lever

Fig. 2

SubLock

Stopper Locator sleeve Gear cover

Fig. 3

1 – 1.5 mm

Hex. head Sub-Stopper (B) screw

Fig. 4

2 – 2.5 mm

Drywall Sub-Stopper (A) screw

Fig. 5

11