ENGLISH
c. Disconnect the plug from the power source and/or the |
battery pack from the power tool before making any |
adjustments, changing accessories, or storing power |
tools. Such preventive safety measures reduce the risk |
of starting the power tool accidentally. |
d. Store idle power tools out of the reach of children and do |
not allow persons unfamiliar with the power tool or these |
instructions to operate the power tool. Power tools are |
dangerous in the hands of untrained users. |
e. Maintain power tools. Check for misalignment or binding |
of moving parts, breakage of parts and any other |
condition that may affect the power tools operation. If |
damaged, have the power tool repaired before use. |
Safety of others
•This tool is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
•Children should be supervised to ensure that they do not play with the appliance.
6. Labels on tool
The label on your tool may include the following symbols:
Many accidents are caused by poorly maintained power |
tools. |
f. Keep cutting tools sharp and clean. Properly maintained |
cutting tools with sharp cutting edges are less likely to |
bind and are easier to control. |
5. Service
a.Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained.
Additional power tool safety warnings
|
| Read |
|
| |
|
| Instructions |
|
| Manual |
|
| |
|
| Use Eye |
|
| Protection |
|
| |
|
| Use Ear |
|
| Protection |
V | Volts | |
A | Amperes | |
Hz | Hertz | ||||
W | Watts | ||||
min | minutes | ||||
..... | Alternating | ||||
|
|
|
|
| Current |
|
|
|
| ..... | Direct |
|
|
| |||
|
|
|
|
| Current |
|
|
|
|
| |
n0 .......
Speed
...... Class II
Construction
...... Earthing
Terminal
...... Safety
Alert Symbol
.../min.. Revolutions or Recipro- cation per minute
•Wear ear protectors with impact drills. Exposure to noise can cause hearing loss.
•Use auxiliary handles supplied with the tool. Loss of control can cause personal injury.
•Hold power tool by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its own cord. Contact with a
“live” wire will also make exposed metal parts of the power tool “live” and shock the operator.
•Use clamps or another practical way to secure and support the workpiece to a stable platform. Holding the work by hand or against your body leaves it unstable and may lead to loss of control.
•Before drilling into walls, floors or ceilings check for the location of wiring and pipes.
•Avoid touching the tip of a drill bit just after drilling, as it may be hot
Electrical safety
This tool is double insulated; therefore no earth wire is
required. Always check that the power supply
corresponds to the voltage on the rating plate.
•If the supply cord is damaged, it must be replaced by the manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Features (Fig. A)
1.Variable speed switch
(Only for HD5010VA5, HD5513V, HD5513KA40,HD5513KHA)
2.
3.Forward/ reverse slider, Depth stop & Side handle (Only for HD5513V, HD5513KHA, KHA40V)
4