Black & Decker BDCDMT120-2, BDCDMT120FL Read all Instructions, Minimum Gauge for Cord Sets Volts

Page 6

Do not use an extension cord unless it is absolutely necessary. Use of improper

extension cord could result in risk of fire,

electric

shock, or

electrocution.

An extension cord must have adequate wire size (AWG or American Wire Gauge) for

 

safety. The smaller the gauge number of the wire, the greater the capacity of the cable, that is

 

16 gauge has more capacity than 18 gauge. When using more than one extension to make up

 

the total length, be sure each individual extension contains at least the minimum wire size.

 

 

 

 

 

 

 

 

 

 

 

 

Minimum Gauge for Cord Sets

 

 

 

Volts

 

0-25

Total Length of Cord in Feet

 

 

 

120V

 

26-50

51-100

101-150

 

 

 

240V

 

(0-7,6m)

(7,6-15,2m) (15,2-30,4m) (30,4-45,7m)

 

 

 

 

0-50

51-100

101-200

201-300

 

 

 

 

 

 

(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)

 

 

 

Ampere Rating

American Wire Gauge

 

 

 

More

Not more

 

 

 

Than

Than

18

16

16

14

 

 

 

0

-

6

 

 

 

6

-

10

18

16

14

12

 

 

 

10 -

12

16

16

14

12

 

 

 

12 -

16

14

12

Not Recommended

 

 

 

 

 

 

 

 

 

 

 

Do not place any object on top of charger or place the charger on a soft surface that might block the ventilation slots and result in excessive internal heat. Place the charger in a position away from any heat source. The charger is ventilated through slots in the top and the bottom of the housing.

Do not mount charger on wall or permanently affix charger to any surface. The charger is intended to use on a flat, stable surface (i.e., table top, bench top).

Do not operate charger with damaged cord or plug — have them replaced immediately.

Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way. Take it to an authorized service center.

Do not disassemble charger; take it to an authorized service center when service or repair is required. Incorrect reassembly may result in a risk of electric shock, electrocution or fire.

Disconnect the charger from the outlet before attempting any cleaning. This will reduce the risk of electric shock. Removing the battery pack will not reduce this risk.

NEVER attempt to connect 2 chargers together.

The charger is designed to operate on standard household electrical power (120 Volts). Do not attempt to use it on any other voltage.

SAVE THESE INSTRUCTIONS Important Safety Instruction for Battery Packs

WARNING: For safe operation, read this manual and manuals originally supplied with tool before using the charger.

The battery pack is not fully charged out of the carton. Before using the battery pack and charger, read the safety instructions below. Then follow charging procedures outlined.

Read all Instructions

Do not incinerate the battery pack even if it is severely damaged or is completely worn out. The battery pack can explode in a fire. Toxic fumes and materials are created when battery packs are burned.

Do not charge or use battery in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Inserting or removing the battery from the charger may ignite the dust or fumes.

If battery contents come into contact with the skin, immediately wash area with mild soap and water. If battery liquid gets into the eye, rinse water over the open eye for 15 minutes or until irritation ceases. If medical attention is needed, the battery electrolyte for Lithium-Ion batteries is composed of a mixture of liquid organic carbonates and lithium salts.

Contents of opened battery cells may cause respiratory irritation. Provide fresh air. If symptoms persist, seek medical attention.

WARNING: Burn hazard. Battery liquid may be flammable if exposed to spark or flame.

Charge the battery packs only in Black & Decker chargers.

6

Image 6
Contents Catalog Number BDCDMT112 12V MAX BDCDMT120 20V MAX Save this manual for Future referenceVEA EL ESPA-OL EN LA Contraportada Safety Guidelines Definitions Work Area Safety Specific Safety Rules Always Wear Certified Safety EQUIPMENT  SymbolsImportant Safety Instructions for Battery Chargers FUNCTIONAL DESCRIPTIONRead all Instructions Minimum Gauge for Cord Sets Volts12volt max* Charging Procedure 20volt Max** Charging Procedure Operating Power Unit Trigger Switch & forward/Reverse sliderOperating Drill/Screwdriver attachment Installing and removing attachments Figure GSafety Warnings and Instructions Drills Fitting and removing a drill bit or screwdriver bitTorque Control figure Make sure switch turns drill on and off Drilling in WoodKeyless Chuck figure H On-board bit storageTroubleshooting Rbrc SealSee ‘Tools-Electric’ Service Information Full Two-Year Home Use WarrantyFor Service & Sales Yellow PagesMode D’EMPLOI De catalogue BDCDMT112 12V MAX BDCDMT120 20V MAXLignes directrices en matière de sécurité définitions Modifiées correspondant à la prisePage Règles de sécurité spécifiques Symboles Description FonctionnelleAvertissement Lire toutes les directives Tension Longueur totale du cordon en pieds12volt max* Procédure de charge Remarques importantes pour le chargement 12volt max* Insertion et retrait du bloc-piles de l’outil20volt Max** Procédure de charge Bloc-piles laissé dans le chargeurInstallation ET Retrait DES Modules Figure G 20volt Max** Insertion et retrait du bloc-piles de l’outilDétente ET Commutateur Coulissant AVANT/ARRIÈRE Avertissement de sécurité et directives perceuses VissageRéglage du couple figure Rangement intégré des mèchesPerçage Perçage DU Métal DépannagePerçage DU Bois EntretienLe sceau Rbrc Information sur les réparationsPage Manual DE Instrucciones Catálogo N BDCDMT112 12V MAX BDCDMT120 20V MAXPautas DE SEGURIDAD/DEFINICIONES Page Normas de seguridad específicas Descripción de las funciones SímbolosAdvertencia Lea todas las instrucciones AmperajeRecomendaciones con respecto al almacenamiento 12volt max* Procedimiento de cargaNotas importantes sobre la carga Herramienta20volt Max** Procedimiento de carga Instalación Y Extracción DE Aditamentos Figura G Para instalar el paquete de baterías Inserte elPara extraer el paquete de baterías Presione el botón Precaución Riesgo de descarga eléctrica. BajoColocación Y Extracción DE UNA Broca O UNA Punta DestornilladoEspacio en la herramienta para guardar brocas Portabrocas sin llave figura HAjuste del control de torsión figura TaladradoMantenimiento El sello Rbrc Información de mantenimientoGarantía completa de dos años para uso en el hogar Reemplazo DE LAS Etiquetas DE AdvertenciaEsta Garantia no Aplica Cuando Solamente Para Propositos DE Mexico