Black & Decker LDX112 instruction manual 75 ft 100 ft 125 ft 150 ft 175 ft, Immediately

Page 6

 

 

 

Recommended Minimum Wire Size for Extension Cords

 

 

Total Length of Cord

75 ft.

100 ft.

125 ft.

150 ft.

175 ft.

 

 

25 ft.

50 ft.

 

 

7.6 m

15.2 m

22.9 m

30.5 m

38.1 m

45.7 m

53.3 m

 

 

Wire Size AWG

16

16

14

14

12

 

 

18

18

 

•

Do

not place any object on top of charger or place the charger on a soft surface

 

 

that might block the ventilation slots and result in excessive internal heat. Place

 

the charger in a position away from any heat source. The charger is ventilated

•

through slots in the top and the bottom of the housing.

 

 

 

Do not mount charger on wall or permanently affix charger to any surface. The

•

charger is intended to use on a flat, stable surface (i.e., table top, bench top).

Do not operate charger with damaged cord or plug — have them replaced

•

immediately.

 

 

 

 

 

 

 

Do not operate charger if it has received a sharp blow, been dropped, or otherwise

•

damaged in any way. Take it to an authorized service center.

 

 

Do not disassemble charger; take it to an authorized service center when service or

 

repair is required. Incorrect reassembly may result in a risk of electric shock,

•

electrocution or fire.

 

 

 

 

 

 

Disconnect the charger from the outlet before attempting any cleaning. This will

•

reduce the risk of electric shock. Removing the battery pack will not reduce this risk.

NEVER attempt to connect 2 chargers together.

 

 

 

•

The charger is designed to operate on standard household electrical power

 

(120 Volts). Do not attempt to use it on any other voltage.

 

 

 

SAVE THESE INSTRUCTIONS

IMPORTANTForSAFETYsafe operation,INSTRUCTIONread this manualFORand manualsBATTERYPACKSoriginally supplied withWARNING:tool before using the charger.

The battery pack is not fully charged out of the carton. Before using the battery pack and charger, read the safety instructions below. Then follow charging procedures outlined.

• Do not incinerate the batteryREADpackALLevenINSTRUCTIONSif it is severely damaged or is completely worn out. The battery pack can explode in a fire. Toxic fumes and materials are created when battery packs are burned.

• Do not charge or use battery in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Inserting or removing the battery from the charger may ignite the dust or fumes.

• If battery contents come into contact with the skin, immediately wash area with mild soap and water. If battery liquid gets into the eye, rinse water over the open eye for 15 minutes or until irritation ceases. If medical attention is needed, the battery electrolytefor Li-ion batteries is composed of a mixture of liquid organic carbonatesand lithium salts.

• Contents of opened battery cells may cause respiratory irritation. Provide fresh air. If symptoms persist, seek medical attention.

Burn hazard. Batteryliquidmaybeflammableifexposedtosparkorflame.

• ChargeWARNING:the battery packs only in Black & Decker chargers.

• DO NOT splash or immerse in water or other liquids. This may cause premature cell failure.

• Do not store or use the tool and battery pack in locations where the temperature may reach or exceed 105°F (40˚C) (such as outside sheds or metal buildings in summer).

Never attempt to open the battery pack for any reason. If battery pack

caseWARNING:is crackedor damaged, do not insert into charger. Do not crush, drop or damage battery pack. Do not use a battery pack or charger that has received a sharp blow, been dropped, run over or damaged in any way (i.e., pierced with a nail, hit with a hammer, stepped on). Damaged battery packs should be returned to service center for recycling.

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents 12V MAX* Cordless Drill General Power Tool Safety Warnings Properly maintained cutting tools with sharp Any powerBattery pack.Use of any Resultperformedin a hazardous. situationAmperes Designed to filter out microscopic particlesIt is important for you to read and understand this manual Volts Hertz WattsElectric shock or electrocution Damage to electric plug and cordThrough slots in the top and the bottom of the housing 75 ft 100 ft 125 ft 150 ft 175 ftImmediately Recycling Completion of charge is indicated by the green LEDUsed at this time or left on the charger Pattern indicated on the labelSafety Warnings and Instructions Drills Torque Control Figure E Trigger Switch & Reversing Button Figure DBefore installing or removing accessories Soft workpiece materialsOn Board BIT Storage MaintenanceScrew Driving DrillingAccessories Allowtocharge701 E. Joppa Rd Imported byBlack & Decker U.S. Inc Towson, MD 21286 U.S.ADE 12V* MAX Sécurité personnelle Utilisation et entretien d’un outil électrique Deélectriquelʼoutil électriquePeut entraîner des blessures corporelles UneExposition au bruit peut entraîner une perte auditive Son cordon. En cas de contact avec un fil sousLa propriété SymbolesSymbole d´avertissement Tours à la minute AmpèresOu une électrocution Guirlande. Cela permet de réduire le risqueDʼendommager la fiche ou le cordondʼalimentation D. un dessus de table ou dʼétabli Remplacer immédiatementSont dégagées lorsque les blocs-piles sont incinérés Manuels fournis avec lʼoutil avant dʼutiliser le chargeurConsignes de chargement décrites Chargeur peut enflammer de la poussière ou des émanationsBloc-piles après chaque utilisation Si le bloc-piles ne se charge pas adéquatement, on doitLa lumière sont éteinte Ne jamais ouvrir le bloc-piles pour Insertion ET Retrait DU BLOC-PILES DE L’OUTILLa position du centre du bouton Réglage DU Couple Figure EAvec une main et utiliser lʼautre pour faire Vissage Rangement Intégré DES MèchesPerçage « Remarques importantes DépannageReporter à la rubrique De chargement » pour plusPage Manual DE Instrucciones DEL Taladro Inalámbrico DE 12V MÁX Seguridad eléctrica Quemadurasterminal al otroo incendio MantenimientoVivas y pueden originar un choque al operador Pueden enganchar.Utilice el mango auxiliar, enProvocar daños personales y materiales Importantes para los cargadores de bateríasEn el cargador El cargador antes de intentar limpiarloDe la cubierta ElectrocuciónPies Riesgo de descarga eléctrica, electrocución o incendioSi el líquido de la batería entra encontacto con los Cargue los paquetes de baterías sólo con cargadoresdeAdvertencia Instrucciones Y Advertencias DE Seguridad Page Portabrocas SIN Llave Figura F Interruptor Disparador Y Botón DE Inversión Figura DAjuste DEL Control DE Torsión Figura E Instalar o retirar accesoriosTaladrado DestornilladoEspacio EN LA Herramienta Para Guardar Brocas Taladrado EN MaderaParaquese cargue Detección DE ProblemasBaterías en el cargador AccesoriosPage Telephone · No. Teléfono Años DE GarantiaEsta Garantia no Aplica Cuando Solamente Para Propositos DE Mexico
Related manuals
Manual 40 pages 30.95 Kb

LDX112 specifications

The Black & Decker LDX112 is a versatile cordless drill/driver that stands out in the world of power tools, offering a balance of performance, convenience, and ease of use. This tool is ideally suited for both DIY enthusiasts and professionals alike, making it an essential addition to any toolkit.

One of the standout features of the LDX112 is its compact design, which allows for easy maneuverability in tight spaces. Weighing just a few pounds, it is lightweight and easy to handle, reducing fatigue during extended use. The ergonomic handle provides a comfortable grip, ensuring that users can work for longer periods without discomfort.

Powering the LDX112 is a 20V MAX lithium-ion battery, which delivers impressive performance and longevity. This battery technology ensures that users get consistent power for the duration of their projects, without the frustrating slowdowns that can come from lower quality batteries. Moreover, the lithium-ion design means that the battery retains its charge for longer periods when not in use, making it an efficient choice for those who may not use their tools daily.

The drill features an 11-position clutch that allows users to adjust torque settings according to the task at hand, which is especially useful when driving different types of screws or working with various materials. This feature minimizes the risk of stripping screws or damaging work surfaces, helping to ensure that every job is completed with precision and care.

Another significant attribute of the LDX112 is the presence of a keyless chuck that accommodates various drill bits with ease. This feature allows for quick and hassle-free bit changes, saving users valuable time when switching tasks. Additionally, the speed settings, which include a two-speed gear system (0-450 RPM and 0-1500 RPM), provide the versatility needed for both drilling and driving applications.

For added convenience, the Black & Decker LDX112 is equipped with an integrated LED work light, illuminating dark areas and enhancing visibility during use. This is particularly advantageous for projects in dimly lit environments where clarity is essential.

In conclusion, the Black & Decker LDX112 combines power, efficiency, and user-friendly features to meet the demands of various tasks. With its lightweight design, powerful lithium-ion battery, adjustable clutch settings, and illuminated work area, this drill/driver is an excellent choice for anyone looking to achieve professional-quality results in their DIY projects or professional jobs.
Top Page Image Contents