Grizzly G0759 owner manual Assembly, Drill Chuck Arbor, To assemble your machine

Assembly

Assembly of the Model G0704 consists of attach- ing the four handwheel handles to the machine.

To assemble your machine:

1.With a #3 standard screwdriver, install the large handwheel handle on the elevation handwheel (Figure 12).

Elevation

Handwheel

Elevation

Handwheel

Handle

Figure 12. Elevation handwheel handle.

2.use the same method to install the three small handwheel handles to the three table travel handwheels (Figure 13).

Figure 13. Table handwheel handles.

Model G0704 (Mfg. Since 08/11)

Drill Chuck Arbor

Your machine includes an B-16 drill chuck arbor and drill chuck. Before use, the drill chuck must be installed onto the arbor. The This drill chuck installation is intended to be semi-permanent.

Tip: For a permanent installation, chill the arbor in the freezer for 15 minutes before performing the following procedure. The taper will expand as it returns to room temperature, permanently locking the chuck.

To install the drill chuck onto the arbor:

1.Clean the grease off the drill chuck and all taper mating surfaces. Pay particular atten- tion to the B-16 bore in the drill chuck—it must be free from all grease, oil, and debris.

2.Retract the drill chuck jaws fully by turning the body of the drill chuck counterclockwise.

3.Insert the arbor into the drill chuck. Tap the arbor lightly with a brass or other soft-headed hammer to get a good fit.  

Note: While it may not seem like there is anything keeping the drill chuck in place, the B-16Taper fit provides a strong bond and will hold the drill chuck tightly (Figure 14).

R-8 Arbor w/

B-16 Chuck

Taper

Brass Tip

Figure 14. Drill chuck.

4.Refer to Page 29 for detailed instructions for installing or removing the drill chuck and arbor in the spindle.

-19-