Polycom 1725-36071-001 manual AP registration

Page 10

Configuration Guide

AP registration

1.Click the Wireless APs button.

2.Click AP registration in the navigation pane.

3.Enter all information for your APs (see screen shot below). Make sure the setting for Security Mode is selected to Allow all Wireless APs to Connect.

4.Click the Save button.

This setting allows new APs to be added to the system automatically. Once the addition of APs is complete, it is recommended to switch this setting back to Allow only approved

Wireless APs to connect.

10	PN: 1725-36071-001_C.doc

Image 10

Contents View Certified Configuration Guide Siemens Trademark Information Introduction Certified Product SummaryNetwork Topology Installing Software & Configuration Initial Setup Controller Setup Assigning an IP address to a wireless controllerConfiguration Guide Assigning routing protocols to a wireless controller AP registration AP maintenance Setting up SSID, Security and QOS Page Filtering Multicast configuration Security Quality of service Setting up other SSIDsConnecting access points to the controller Wireless APs address assignment 802.11b/g settings For Enable Radios, select the 802.11b check box Enable the radio