Polycom 1725-36071-001 manual Connecting access points to the controller

Page 18

Configuration Guide

Connecting access points to the controller

1.Click the Reports button.

2.Make sure the controller is configured to accept new APs (this is selected by default).

3.Physically connect the access points to the system one at a time. Once an AP is connected to the system, it will show up in the

Active Wireless APs screen of the Reports menu.

4.Press F5 to refresh the screen.

18	PN: 1725-36071-001_C.doc

Image 18

Contents View Certified Configuration Guide Siemens Trademark Information Introduction Certified Product SummaryNetwork Topology Installing Software & Configuration Initial Setup Controller Setup Assigning an IP address to a wireless controllerConfiguration Guide Assigning routing protocols to a wireless controller AP registration AP maintenance Setting up SSID, Security and QOS Page Filtering Multicast configuration Security Quality of service Setting up other SSIDsConnecting access points to the controller Wireless APs address assignment 802.11b/g settings For Enable Radios, select the 802.11b check box Enable the radio