Polycom 1725-36071-001 manual Enable the radio

Page 22

Configuration Guide

Enable the radio

1.Click the VNS Configuration button.

2.Click the Topology tab.

3.Enable each AP’s b/g radio for each SSID.

4.Set No. of Retries for Voice VO to adaptive (multi-rate) and No. of Retries for Turbo Voice TVO to 2.

5.Click the Save button.

After the controller and access points are set up, the Management port is no longer required. The Controller can now be managed through the Host Port, or the esa0 port in this configuration. Open a browser and connect to https://<ip address>:5825.

22	PN: 1725-36071-001_C.doc

Image 22

Contents View Certified Configuration Guide Siemens Trademark Information Introduction Certified Product SummaryNetwork Topology Installing Software & Configuration Initial Setup Controller Setup Assigning an IP address to a wireless controllerConfiguration Guide Assigning routing protocols to a wireless controller AP registration AP maintenance Setting up SSID, Security and QOS Page Filtering Multicast configuration Security Quality of service Setting up other SSIDsConnecting access points to the controller Wireless APs address assignment 802.11b/g settings For Enable Radios, select the 802.11b check box Enable the radio