Polycom 1725-36071-001 manual 802.11b/g settings

Page 20

Configuration Guide

For each AP, follow the steps in the following sections:

AP properties

1.In the Wireless APs screen, click the AP Properties tab. Select an AP to configure. Here you can assign a meaningful name to each AP.

2.Enable Telnet Access. This is useful for troubleshooting the setup and configuring security settings.

802.11b/g settings

1.In the Wireless APs screen, select the 802.11 b/g tab.

2.Select an AP to configure.

3.Under Base Settings:

a.Set the DTIM Period to 3.

b.Set the Beacon Period to 100.

c.Set the RTS/CTS Threshold to 2346.

d.Set the Frag. Threshold to 2346.

20	PN: 1725-36071-001_C.doc

Image 20

Contents View Certified Configuration Guide Siemens Trademark Information Introduction Certified Product SummaryNetwork Topology Installing Software & Configuration Initial Setup Controller Setup Assigning an IP address to a wireless controllerConfiguration Guide Assigning routing protocols to a wireless controller AP registration AP maintenance Setting up SSID, Security and QOS Page Filtering Multicast configuration Security Quality of service Setting up other SSIDsConnecting access points to the controller Wireless APs address assignment 802.11b/g settings For Enable Radios, select the 802.11b check box Enable the radio