What water to use ?
Your appliance has been designed to function with tap water. However, it is necessary to operate the
50% tap water, 50% demineralized water.
Types of water not to use :
Heat concentrates the elements contained in water during evaporation. The types of water listed below contain organic waste or mineral elements that can cause spitting, brown staining, or premature wear of the appliance: water from clothes dryers, scented or softened water, water from refrigerators, batteries, or air conditioners, pure distilled water, or rain water.
1- STEAM IRONING
A | B | C | D | E | F |
Filling the water tank
-Unplug your iron before filling it.
-Set the steam control on DRY (A).
-Fill the beaker up to the lower line indicated (B).
-Open the water tank filler cover completely (C), set the iron on a table (not when the iron is hot) shown in the diagram (D) below, and fill the tank.
-Do not exceed the MAX line indicated on the water tank (with the iron set on its heel).
-Close the water tank filler cover.
Setting the temperature
- Set the temperature control shown in the diagram below (E) referring to the table below (or on the heel). - The thermostat light comes on.Wait for the light to go off and come on again before you start ironing (F).
Setting the steam level (G)
| - In order to avoid water dripping from the iron onto the linen: |
| ||
| • | Turn off the steam when ironing silk or synthetic fabrics. |
| |
| G | |||
2 | • | Set it at the minimum position for wool. | ||
|