HP xw460c Blade manual System Access configuration, Management Networks configuration

System Access configuration

Command: /cfg/sys/access

[System Access Menu]

mgmt	- Management Network Definition Menu
user	- User Access Control Menu (passwords)
http	- Enable/disable HTTP (Web) access
https	- HTTPS Web Access Menu
wport	- Set HTTP (Web) server port number
snmp	- Set SNMP access control
tnport	- Set Telnet server port number
tport	- Set the TFTP Port for the system
cur	- Display current system access configuration

The following table describes the System Access Configuration menu options.

Table 94 System Access Configuration Menu options

Command	Description
mgmt	Displays the Management Configuration Menu.
user	Displays the User Access Control Menu.

http disableenable Enables or disables HTTP (Web) access to the Browser-based Interface. It is enabled by default.

https	Displays the HTTPS Menu.
wport <TCP port	Sets the switch port used for serving switch Web content. The default is HTTP port 80.
number>
snmp disableread-	Disables or provides read-only/write-read SNMP access.
onlyread-write
tnport <TCP port	Sets an optional telnet server port number for cases where the server listens for telnet sessions
number>	on a non-standard port.
tport <TFTP port	Sets an optional telnet server port number for cases where the server listens for TFTP sessions
number>	on a non-standard port.
cur	Displays the current system access parameters.

Management Networks configuration

Command: /cfg/sys/access/mgmt

[Management Networks Menu]

add	- Add mgmt network definition
rem	- Remove mgmt network definition
cur	- Display current mgmt network definitions

The following table describes the Management Networks Configuration menu options. You can configure up to 10 management networks on the switch.

Table 95 Management Networks Configuration menu options

Command	Description
add <IP address> <IP mask>	Adds a defined network through which switch access is allowed
	through Telnet, SNMP, RIP, or the browser-based interface. A range
	of IP addresses is produced when used with a network mask
	address. Specify an IP address and mask address in dotted-decimal
	notation.
rem <IP address> <IP mask>	Removes a defined network, which consists of a management
	network address and a management network mask address.
cur	Displays the current management networks parameters.

Configuration Menu 104