HP xw460c Blade manual Port Rmon statistics

Page 69

Port RMON statistics

Command: /stats/port <port number>/rmon

RMON statistics for port 2:

etherStatsDropEvents:NA

etherStatsOctets:0

etherStatsPkts:0

etherStatsBroadcastPkts:0

etherStatsMulticastPkts:0

etherStatsCRCAlignErrors:0

etherStatsUndersizePkts:0

etherStatsOversizePkts:0

etherStatsFragments:NA

etherStatsJabbers:0

etherStatsCollisions:0

etherStatsPkts64Octets:0

etherStatsPkts65to127Octets:0

etherStatsPkts128to255Octets:0

etherStatsPkts256to511Octets:0

etherStatsPkts64Octets:0

etherStatsPkts1024to1518Octets:0

The following table describes the Remote Monitoring (RMON) statistics of the selected port:

Table 52 RMON statistics

Statistic

Description

 

 

etherStatsDropEvents

The total number of packets received that were dropped because of system

 

resource constraints.

 

 

etherStatsOctets

The total number of octets of data (including those in bad packets) received

 

on the network (excluding framing bits but including FCS octets).

 

 

etherStatsPkts

The total number of packets (including bad packets, broadcast packets, and

 

multicast packets) received.

 

 

etherStatsBroadcastPkts

The total number of good packets received that were directed to the

 

broadcast address.

 

 

etherStatsMulticastPkts

The total number of good packets received that were directed to a multicast

 

address.

 

 

etherStatsCRCAlignErrors

The total number of packets received that had a length (excluding framing

 

bits, but including FCS octets) of between 64 and 1518 octets, inclusive, but

 

had either a bad Frame Check Sequence (FCS) with an integral number of

 

octets (FCS Error) or a bad FCS with a non-integral number of octets

 

(Alignment Error).

 

 

etherStatsUndersizePkts

The total number of packets received that were less than 64 octets long

 

(excluding framing bits but including FCS octets) and were otherwise well

 

formed.

 

 

etherStatsOversizePkts

The total number of packets received that were longer than 1518 octets

 

(excluding framing bits but including FCS octets) and were otherwise well

 

formed.

 

 

etherStatsFragments

The total number of packets received that were less than 64 octets in length

 

(excluding framing bits but including FCS octets) and had either a bad

 

Frame Check Sequence (FCS) with an integral number of octets (FCS Error)

 

or a bad FCS with a non-integral number of octets (Alignment Error).

 

 

etherStatsJabbers

The total number of packets received that were longer than 1518 octets

 

(excluding framing bits, but including FCS octets), and had either a bad

 

Frame Check Sequence (FCS) with an integral number of octets (FCS Error)

 

or a bad FCS with a non-integral number of octets (Alignment Error). Jabber

 

is defined as the condition where any packet exceeds 20 ms. The allowed

 

range to detect jabber is between 20 ms and 150 ms.

 

 

etherStatsCollisions

The best estimate of the total number of collisions on this Ethernet segment.

 

 

Statistics Menu 69

Page 68 Page 70
Image 69
Page 68 Page 70
Contents HP GbE2c Ethernet Blade Switch for c-Class BladeSystem Page Contents Statistics Menu Configuration Menu 111 Index Command line interface Introduction Connecting to the switchAdditional references Establishing a console connectionTelnet GbE2c Ethernet Blade Switch IP address Setting an IP addressEstablishing a Telnet connection Establishing an SSH connection# ssh user@GbE2c Ethernet Blade Switch IP address Accessing the switchIdle timeout AaBbCc123 Typographical conventionsMenu summary Main MenuGlobal commands DelayTraceroute host name IP address max-hops msec Telnet hostname IP address port Command line history and editingCommand stacking Command line interface shortcutsCommand abbreviation Tab completion# /cfg/sys/access/snmp disableread onlyread/write Configuring Simple Network Management Protocol supportMain# /cfg # /cfg/sys/ssnmp/rcommwcommSetting passwords Changing the default administrator passwordSystem# apply System# save Changing the default user password Changing the default operator password Menu overview Information MenuSNMPv3 Information Menu System Information MenuSNMPv3 USM User Table information AdminshaComm V1v2onlySNMPv3 View Table information SNMPv3 Access Table informationSNMPv3 Group Table information SNMPv3 Community Table informationPrefix SNMPv3 Target Parameters Table information SNMPv3 Target Address Table informationCommand /info/sys/snmpv3/notify NameTag V1v2trapv1v2trap SNMPv3 Notify Table informationSec Level SNMPv3 dump System information System user information Show last 100 syslog messagesCfg/sys/access/user/uid command Layer 2 information8021x Stp FDB information menu Find MAC address VlanPort port number Show all FDB information Link Aggregation Control Protocol informationLacp dump 802.1x information Authenticator PAE State Port Auth ModeCommand /info/l2/stp Spanning Tree informationPath-Cost Current RootPriority bridge HelloDesignated port Rapid Spanning Tree and Multiple Spanning Tree informationDesg 8017 P2P2,Edge Desg 8018Disabled DSB Common Internal Spanning Tree information Disabled DSB Trunk group informationDiscarding Disc , Learning LRN , Forwarding FWD , or Vlan information Layer 2 general informationLayer 3 information Find IP address Route informationGw IP address If IP addressShow all IP Route information ARP information Command /info/arp/dump IP address Flags MAC addressShow all ARP entry information VlanOspf information Nbr nbr router-id A.B.C.DDbase Sumaddr Nsumadd Routes Dump Ospf general information Ospf interface informationOspf Database information menu Asbrsum adv-rtr A.B.C.D Linkstateid A.B.C.Dself Advrtr router-id A.B.C.DExt adv-rtr A.B.C.D linkstateid A.B.C.Dself Nw adv-rtr A.B.C.D linkstateid A.B.C.DselfOspf route codes information Routing Information Protocol informationRIP Routes information RIP user configuration IP informationIgmp multicast group information Command /info/l3/vrrp Vrrp information Igmp multicast router port informationVrrp information 802.1p information QoS informationQoS Menu 8021p Show QOS 802.1p information 8021pRmon Information Menu ACL informationInterval Rmon history informationRmon alarm information Command /info/rmon/eventRmon event information Link status information Command /info/port Port Tag Rmon Pvid Port informationVLANs Uplink Failure Detection Enabled LtM status Down Member Command /info/geaport Logical Port GEA Port0-based GEA UnitLogical Port to GEA Port mapping Uplink Failure Detection informationInformation dump Command /info/dumpMenu information Ntp clearUfd clear Port Statistics Menu Authenticating 802.1x statisticsAuthSuccessesWhile Bridging statistics BackendNonNakResponsesFromSupplicant Ethernet statistics Dot3StatsInternalMacTransmitErrors Dot3StatsFCSErrorsDot3StatsSingleCollisionFrames Dot3StatsMultipleCollisionFramesInterface statistics Link statistics Internet Protocol IP statisticsPort Rmon statistics FDB statistics Layer 2 statisticsLayer 3 statistics Lacp statisticsArp clear Clrigmp 1- 4095 allGEA Layer 3 statistics GEA Layer 3 statistics menuIP statistics L3 bucket for An IP address DumpARP statistics Route statisticsIcmp statistics DNS statisticsTCP statistics UDP statistics Igmp Multicast Group statistics Command /stats/l3/ospfOspf statistics menu Ospf stats MenuOspf global statistics Nbr change Tx ls UpdatesVrrp statistics Timers KickoffManagement Processor statistics Command /stats/l3/ripRIP statistics Packet statistics10ad41e8/10ad5790 AllocsAccess Control List ACL statistics menu CPU statisticsACL statistics Snmp statistics Only NTP statistics Uplink Failure Detection statistics Command /stats/dumpStatistics dump Number of times LtM link in BlockingConfiguration Menu Viewing, applying, reverting, and saving changes Saving the configurationViewing pending changes Applying pending changesReminders System configurationLine to end System host log configurationBannr 1-80 characters Host IP addressSecure Shell Server configuration Console disableenableLog featureall enabledisable Command /cfg/sys/radius Radius server configurationIntrval Sshport TCP port numberTACACS+ server configuration Port TCP port number Telnet enabledisableSystem Snmp configuration NTP server configurationDlight disableenable Command /cfg/sys/ssnmpSNMPv3 configuration Name 1-64 charactersCharacters V1v2 disableenable User Security Model configurationName 1-32 characters SNMPv3 View configurationTree 1-32 characters Mask 1-32 charactersSNMPv3 Group configuration View-based Access Control Model configurationUsmsnmpv1snmpv2 Level NoAuthNoPrivauthNoSNMPv3 Community Table configuration Usmsnmpv1snmpv2 UnameDel Deletes the vacmSecurityToGroup entry Cur SNMPv3 Target Parameters Table configuration SNMPv3 Target Address Table configurationAddr transport Address ip Port transportSnmpv1snmpv2csnmp Model SNMPv3 Notify Table configurationManagement Networks configuration System Access configurationUser Access Control configuration User ID configurationUseroperadmin Name Port configuration Https Access configurationAccess enabledisable Name 1-64 characters none Temporarily disabling a port Port link configurationLayer 2 configuration 802.1x configurationPort ACL/QoS configuration 802.1x Global configuration Mode forceUnauthautoforce-auth Reauth onoff 802.1x Port configurationRev Mode rstpmstpBridge parameter menu Common Internal Spanning Tree configurationPort parameter menu 4095Cist port configuration Cist bridge configurationEdge disableenable Spanning Tree configurationCost Link autop2psharedBridge Spanning Tree configuration Cur Display current port Spanning Tree parameters Spanning Tree port configurationForwarding Database configuration Static FDB configurationFastfwd disableenable MAC address Vlan port Trunk configurationClear mac MAC AddressVLAN 1-4095 Port port numberAll Add port numberIP Trunk Hash configuration Layer 2 IP Trunk Hash configurationLink Aggregation Control Protocol configuration Vlan configuration Lacp Port configurationTimeout shortlong Mode offactivepassiveLayer 3 configuration Port numberList of port numbers IP interface configuration Addr IP addressMask IP subnet mask Default Gateway configuration IP Static Route configurationIP Forwarding configuration Address Resolution Protocol configurationNetwork Filter configuration Dirbr disableenableRoute Map configuration Ap AS number AS number ASLp 0-4294967294 none Autonomous System Path configuration IP Access List configurationMetric 1-4294967294none Action permitdenyRouting Information Protocol configuration RIP Interface configuration RIP Route Redistribution configuration Open Shortest Path First configurationAdd 1-32 1-32all Remove 1-32 1-32allDefault 1-16777215 12none Osfp Area Index configurationMd5key 1-255 characters Redist fixedstaticripAuth nonepasswordmd5 Ospf Summary Range configurationAreaid IP address Type transitstubnssaMask IP address mask Ospf Interface configurationKey key stringnone Mdkey 1-255noneOspf Virtual Link configuration Key passwordNbr IP address Ospf Route Redistribution configuration Ospf Host Entry configurationRem 1-32 1-32 ... all Export 1-16777215 12noneOspf MD5 Key configuration Igmp configurationAggr disableenable Igmp snooping configurationFastlv 1-4095 disableenable Srcip IP addressIgmp filtering configuration Igmp static multicast router configurationAdd port number 1-4095 FilterIgmp filter definition Igmp filtering port configurationRange IP multicast address IP Multicast addressDomain Name System configuration Bootstrap Protocol Relay configurationVrrp Virtual Router configuration Virtual Router Redundancy Protocol configurationPreem disableenable Vrrp Virtual Router Group configuration Vrrp Virtual Router Priority Tracking configurationVrs disableenable Ifs disableenableVrrp Virtual Router Group Priority Tracking configuration Vrrp Interface configuration Vrrp Tracking configurationPassw password Quality of Service configuration Access Control configurationQoS 802.1p configuration Egrport port number Access Control List configurationAction permitdenysetprio Stats edACL IP Version 4 Filter configuration ACL Ethernet Filter configurationACL TCP/UDP Filter configuration Sport 1-65535 port maskFlags value 0x0-0x3f ACL Re-mark configuration ACL Meter configurationEnable ed CirACL Re-mark In-Profile configuration ACL Re-mark In-Profile Update User Priority configurationACL Re-mark Out-of-Profile configuration Remote Monitoring configuration ACL Packet Format configurationACL Group configuration Rmon history configuration Ifoid 1-127 charactersOwner 1-127 characters Rmon alarm configuration Rmon event configurationDescn 1-127 characters Type nonelogtrapbothRlimit -2147483647 to Port mirroring2147483647 Flimit -2147483647 toPort-based port mirroring Uplink Failure Detection configurationAdd mirrored port inoutboth Rem mirrored portLink to Monitor configuration Failure Detection Pair configurationAddport port number Remport port numberLink to Disable configuration Saving the active switch configurationDump Addport port number Remport port numberRestoring the active switch configuration Command /cfg/gtcfg FTP/TFTP server filenameConfiguration# gtcfg FTP/TFTP server filename Operations-level port options Operations MenuReset Reauth Operations-level port 802.1x optionsOperations-level Vrrp options Downloading new software to the switch Updating the switch software imageAddress Selecting a software image to runSelecting a configuration block Uploading a software image from the switchBoot Options# ptimg Boot Options# confAccessing the Iscli Resetting the switchBoot Options# reset Boot Options# curMaintenance Menu Forwarding Database options System maintenance optionsFlags new Nvram flags word as 0xXXXXXXXXARP cache options Debugging optionsIP Route Manipulation options Igmp Multicast Group optionsBroadcastmartian Igmp Mrouter options Igmp Snooping optionsUuencode flash dump FTP/TFTP system dump putClearing dump information Command /maint/panic Panic commandConfirm dump and reboot y/n y Unscheduled system dumpsIndex
Related manuals
Manual 33 pages 57.51 Kb
Top Page Image Contents