HP xw460c Blade manual Lacp Port configuration, Vlan configuration, Timeout shortlong

The following table describes the LACP Configuration Menu options.

Table 118 LACP Configuration Menu options

Command	Description
sysprio <1-65535>	Defines the priority value (1 through 65535) for the switch. Lower
	numbers provide higher priority. The default value is 32768.
timeout shortlong	Defines the timeout period before invalidating LACP data from a remote
	partner. Choose short (3 seconds) or long (90 seconds). The default
	value is long.
	Note: HP recommends that you use a timeout value of long, to reduce
	LACPDU processing. If your switch’s CPU utilization rate remains at 100%
	for periods of 90 seconds or more, consider using static trunks instead of
	LACP.
port <port number>	Displays the LACP Port menu.
cur	Display current LACP configuration.

LACP Port configuration

Command: /cfg/l2/lacp/port <port number>

[LACP Port 2 Menu]

mode	- Set LACP mode
prio	- Set	LACP port priority
adminkey	- Set	LACP port admin key
cur	- Display current LACP port configuration

The following table describes the LACP Port Configuration Menu options.

Table 119 LACP Port Configuration Menu options

Command	Description
mode offactivepassive	Set the LACP mode for this port, as follows:
	•	off
		Turn LACP off for this port. You can use this port to manually configure a
	•	static trunk. The default value is off.
		active
	•	Turn LACP on and set this port to active. Active ports initiate LACPDUs.
		passive
		Turn LACP on and set this port to passive. Passive ports do not initiate
		LACPDUs, but respond to LACPDUs from active ports.
prio <1-65535>	Sets the priority value for the selected port. Lower numbers provide higher
	priority. Default is 128.
adminkey <1-65535>	Set the admin key for this port. Only ports with the same admin key and oper
	key (operational state generated internally) can form a LACP trunk group.
cur	Displays the current LACP configuration for this port.

VLAN configuration

Command: /cfg/l2/vlan <1-4095>

[VLAN 1 Menu]
name	- Set VLAN name
stg	- Assign VLAN to a Spanning Tree Group
add	- Add port to VLAN
rem	- Remove port from VLAN
def	- Define VLAN as list of ports
ena	- Enable VLAN
dis	- Disable VLAN
del	- Delete VLAN
cur	- Display current VLAN configuration
	Configuration Menu 121