HP 2500C manual Make sure the printer is turned on, Remove the protective tape from each printhead

HP	2500C/C+/CM		Step 6 - Install Printheads
1	1.	Make sure that the Ink Cartridge Door is open. Grasp the side of the
		Printhead Access Cover and lift up firmly to snap the cover open and
		completely remove it from the printer. You may have to use some force
		to open the cover.
		Note: If the cradle cannot be found under the cover, it means that the tape
		securing the cradle has not been removed. Open the Top Cover, remove the tape
		securing the cradle, turn off the printer and turn on again.
2	2.	Make sure the printer is turned ON.
		The cradle will move away slightly. Open the purple printhead latch by
		lifting the latch from the rear. Pull the latch forward and down to
		release the latch hook from the purple carriage lock. Then lift and
		push the latch toward the back of the printer.

3

3.Remove each printhead from its package.

Remove the protective tape from each printhead.

Insert each printhead into its own color-coded socket.

Push the printheads down firmly.

8