1 |
1 |
2 |
16
Loading Media in the Rear Manual Feed
1.Set your printer software to pick paper from Rear Manual Feed and
print your document.
For more information on how to set your print settings, please refer to the section on Changing Print Settings.
2.After sending your print job to the printer, the LCD panel will display the message "MNL FEED LOAD [TYPE] [SIZE]" where [TYPE] and [SIZE] are the media type and size as specified in your printer software.
3.Insert the media into the Rear Manual Feed at the back of the printer, making sure that the edge of the sheet is aligned with the alignment mark on the left side of the slot. Wait for the printer to grip the media before releasing it.
4.Press to start printing.
Click to see a video clip of the above procedure
Monitoring and Replacing Ink Cartridges
The printer monitors and shows the amount of ink left in each ink cartridge on the LCD. When the ink in a particular ink cartridge is about to be used up, a warning message will appear on the LCD Panel. At this point, your ink cartridge will still have enough ink left in it for a few more print jobs. However, it is recommended that you get a replacement ready as soon as this warning message appears.
When the ink in a particular ink cartridge has fully run out, the LCD will display a message [X INK OUT, REPLACE CART] (where X is the color of the cartridge). When this happens, you will not be able to print until the corresponding cartridge is replaced.
To do this:
1.Lift to open the Ink Cartridge Door.
2.Remove the ink cartridge from its packaging and insert it into its own
3.Push down the ink cartridge firmly.
Click to see a video clip of the above procedure.
Note:
Use only original No. 10 HP ink cartridges. The use of incompatible cartridges may disrupt the intricate printing system, potentially resulting in reduced print quality and even damaging the printer. HP does not guarantee