HP D6028-90004 manual Connecting the Battery Pack and Cables

Chapter 3 Hardware Installation and Configuration

CAUTION The HP TopTools Remote Control card is sensitive to static electricity and can easily be damaged by improper handling. Use of an antistatic service kit, such as 3M® 8501/8502/8505 or equivalent is recommended.

To mount the battery pack:

1.Place the HP TopTools Remote Control card on a clean non-conductive surface and disconnect the battery cable from the card.

2.With reference to Figure 3-1, the cooling vents on the battery pack should be on the same side as the board components. Be sure the battery cable is situated on the right and can easily reach the battery connector on the card.

	Cooling vents
1. Slide battery	3. Plug battery
onto board	cable into battery
	connector.

2. Insert darts from rear side of board

Figure 3-1. Connecting the Battery Pack and Cables

3.Make sure that the battery pack is securely mounted to the card using two of the supplied plastic darts. These must be pressed in from the back (the circuit side) of the card. The third dart in the package is a spare.

NOTE	In case the battery must be removed (for exchange or
	replacement), use a screwdriver or a coin to remove the darts.

17