HP D6028-90004 Installing pcANYWHERE32 on the Server, Installing pcANYWHERE32 Server Software

Chapter 6 Setting Up NT Graphics Console Redirection Using pcANYWHERE32

Installing pcANYWHERE32 on the Server

To enable console redirection (the ability to redirect what’s graphically displayed on your server) either over the LAN or via modem, you must first install the pcANYWHERE32 host software, included with your system, on your HP NetServer.

NOTE	Remember that the HP TopTools Remote Control card
	software license authorizes a single administrator for each
	copy of software (including Symantec’s pcANYWHERE32).

Console Redirection Over a LAN

If you want console redirection (remote control) of your server over a LAN (instead of using a modem with pcANYWHERE32), you must have TCP/IP software installed on your server. TCP/IP is available with the standard Windows NT product.

Installing pcANYWHERE32 Server Software

Installing pcANYWHERE32 at the server requires administrator privileges in order to configure the program’s communications features. Your server must be running either Windows NT 3.51 or 4.0.

To install the pcANYWHERE32 software at your Windows NT server:

1.Log in to Windows NT with administrator privileges. You need to be the system administrator, or have an account that belongs to the administrator group.

2.Insert the HP NetServer Navigator CD (supplied with HP TopTools Remote Control) in the CD-ROM drive.

3.If you want to run pcANYWHERE32 via the modem connected to the HP TopTools Remote Control card, install the appropriate NT serial driver by running one of the following NT driver setup programs.

For Windows NT 4.0, the driver is located in: x:\ttrc\us\nt40drvr\setup.exe

For Windows NT 3.51, the driver is located in:

x:\ttrc\us\nt35drvr\setup.exe

where x: is the letter of your CD-ROM drive. Follow the on-screen setup instructions.

42