HP D6028-90004 manual Failure Codes, Suggested Actions

Appendix F LED Codes

For example, a 2-1-1-2error (DRAM Error) would appear as:

flash-flash, pause, flash, pause, flash, pause, flash-flash, pause

The failure pattern repeats indefinitely.

Failure Codes

The table below lists the error or report codes, which are flashed by the HP TopTools Remote Control card’s red diagnostic LED. A flashing red LED always indicates a problem with the card’s operation.

To determine a Suggested Action, note the first three digits of the error and refer to the Report Code in the following table. The fourth digit is represented by an "X" because the number is irrelevant to the analysis.

Table F-1. Failures and Suggested Actions

Report Code

(Red LED blink pattern)

LED on continuously

1111

211X

311X

411X

511X

611X

Failure Reason

ASIC CPU Subsystem Error

FLASH-ROM Error

DRAM Error

LAN Interface Error

RS-232 Interface Error

PCI Interface Error

ICMB Error

Suggested Action

See action 1

See action 2

See action 3

See action 1

See action 1

See action 1

See action 1

The "X" in the report code represents a possible number between 1 and 9 and is not significant.

Suggested Actions

The following remedies refer to the Suggested Actions listed in the last column of Table F-1 above.

Action 1: First verify the fault. Disconnect the AC/DC adapter from the card and cycle power at the server to restart HP TopTools Remote Control. If the same error is reported again, call your local support center.

92