HP D6028-90004 manual Setting Up a LAN Connection, Preparation for Firmware Update

Chapter 4 Setting Up the Remote Connection

download the desired version onto your card. Note that once you select "Start Firmware Update" the update begins immediately.

HP TopTools			Remote	Control for HP NetServers		- Firmware Update Settings
<S> Start			Firmware		Update
<F> Set		Firmware		Image Filename		firmimg.bin
<A>	Set	IP-Address			of Firmware TFTP Server	127.0.0.1
<M>	Main Menu

Figure 4-6. Preparation for Firmware Update

After firmware update is finished you will be prompted to reboot the card, so the new settings can take effect.

NOTE	If you don’t see this prompt or the connection to the HP
	TopTools Remote Control card is interrupted during the
	firmware update, repeat this update before rebooting the card.

Setting Up a LAN Connection

You can communicate with remote clients by connecting to your local 10Base-T compatible network using the RJ-45 jack located at the rear bracket of the HP TopTools Remote Control card and an appropriate cable.

The following figure illustrates a LAN connection joining an HP NetServer (with HP TopTools Remote Control card) and a remote client.

Remote Client

RJ-45 cable

Office LAN jack

HP TopTools Remote Control card to 10Base-T or 10/100 Hub

Figure 4-7. Remote Connection via the LAN

28