Chapter 6 | Setting Up NT Graphics Console Redirection Using pcANYWHERE32 |
2.At the pcANYWHERE32 main screen, click the Remote Control action button from the action button bar. You will see the Remote Control connection items displayed.
Figure 6-4. pcANYWHERE32 Remote Control Connection Items
3.Create a new connection item to access your HP NetServer by double- clicking the "Add Remote Control Item". An installation Wizard prompts you for information needed to set up a new connection item.
4.The Wizard first prompts you for the name of a "New Host to Call". Enter the name of the HP NetServer where you installed the HP TopTools Remote Control card and click Next.
5.Select a connection device. Configure the connection item depending on the type of connection you require. Choose either of the following:
◊LAN connection: If you are setting up a LAN connection item, select TCP/IP and proceed to the following LAN section.
◊Modem connection: If you are setting up a modem connection item, select an installed modem and proceed to the following modem section.
| NOTE | For both Windows NT and Windows 95, you must have a | |
|
| modem already installed to complete the configuration. If the | |
|
| PC you intend to use as the remote client does not have a | |
|
| modem installed and recognized by Windows, you must install | |
|
| one to proceed. | |
|
|
|
|
|
|
|
|
|
| 47 | |