HP D3604-90004 manual Removing a Hot-Swap Disk Module, Installing the Hot-Swap Disk Module

Page 33

3 Installing Hardware Accessories

E nglish

Figure 3-2. Installing the Hot-Swap Disk Module

Removing a Hot-Swap Disk Module

This section describes the process for removing a hot-swap disk module.

CAUTION The module may be spinning and may be warm to touch.

Complete the following procedure to remove a disk module:

1.Verify the hot-swap disk module keylock is unlocked, and unlock the hot- swap disk module by pushing the locking tab down and lifting the front lever.

2.Support the bottom of the module as shown in Figure 3-3. Slowly pull the module straight out. Do not allow the hot-swap disk module to fall.

27

Image 33

Contents HP NetServer Storage System/6 User Guide Audience Assumptions Contents Contents Regulatory Information Page Introduction Introduction Basic InstallationUnpacking the NetServer Storage System/6 Contents of the NetServer Storage System/6 PackageFront View of the Storage System Identifying Parts of the NetServer Storage System/6Nglish Scsi Power Supply Reset Reset SwitchGeneral Operating Instructions Self-TestContinuous Operation Power CyclingPlacement Temperature ControlUsing an Uninterruptible Power Supply Hot-Swap Disk Module Care and RelocationSpin Up Cabling Storage Devices and Setting Scsi Addresses Opening the Door Removing the Bezel and Opening the Door Storage System Switch Location Setting Scsi AddressesSettings Switch FunctionsExternal Cabling Cabling ConfigurationsUpper Cage Lower CageSystem or Meter Cable Accessory Scsi Port Number Meter Cable Number Storage System Layout Cabling Diagram LabelPart Description NumberC11 Default Cabling Configuration Non-DuplexC20 C14Duplex Configuration Duplex ConfigurationC11 C14 Alternate Non-Duplex ConfigurationAlternate Duplex Configuration Alternate Duplex ConfigurationPage Installing Hardware Accessories Installing Hot-Swap Storage DevicesUnpacking a Hot-Swap Disk Module Installing Hardware Accessories Installing a New Hot-Swap Disk ModuleRemoving a Hot-Swap Disk Module Installing the Hot-Swap Disk ModuleRemoving the Hot-Swap Disk Module Installing a Scsi Device in a Scsi Device Shelf Installing Hardware Accessories Troubleshooting Procedures TroubleshootingTroubleshooting If The System Will Not Power OnIf the LED Readout Shows a Line Fault LF If the LED Readout Shows a Fan Fault FFIf the LED Readout Shows a Power Supply Fault PF If the Scsi Devices Fail to Spin UpIf the Host Cannot Communicate With the Storage System If the Hot-Swap Disk Power LEDs are Flashing Troubleshooting Tools Error MessagesNglish Page Service and Support ServiceSystem Design, Integration and Support Service and Support Information and Support When You Need ItHP NetServer Information Assistant CompuServe Discussion Forum and Library HP Support Assistant CD-ROMWorld Wide Web and Internet FTP Bulletin Board SystemAutomated Fax Telephone Support HP NetServer Support NewsObtaining HP Repair and Telephone Support Ordering System Documentation Ordering HP Cables, Drive Trays and ManualsNorth America and Asia Ordering HP Cables, Drive Trays and Technical PublicationsJoining CompuServe Contacting HP Regional HeadquartersCompuServe CompuServe Europe Page NetServer Storage System/6 On-Site Limited Warranty Warranty and Software LicenseThree Year On-Site Limited Hardware Warranty Limitation of WarrantyWarranty and Software License Obtaining Warranty ServiceLimitation of Liability and Remedies Nglish Customer Responsibilities Obtaining Return Warranty Service Software Product Limited WarrantyNinety-Day Limited Software Warranty Removable Media if suppliedWarranty and Software License Notice of Warranty Claims Weight and Dimensions SpecificationsPower Supply Specifications EnvironmentPage Class B Product Statement Regulatory InformationRegulatory Information Country NoticesDeclaration of Conformity Regulatory Information Póliza de Garantía Mexico Hardware Warranty StatementNotas Index BiosIndex Nglish