Installer setup − Page 5 of 8
Modify communicating device settings
Use this screen (figure 12) to access communicating devices’ settings. Use back to return to the previous screen or next step to go on.
setup |
| HELP |
| HP | to adjust a setting, highlight it, |
| then press edit | |
|
|
setup
system devices
HP XP19−060−230−06 5809K00015
AIR HANDLER CBX32MV−60 5809K00020
THERMOSTAT 49W95 A109K00139
SYSTEM
HELP
to adjust a device, highlight it, then press edit
about
edit
reset ALL
back | next step |
Equipment Name |
|
|
Compressor Short |
| Current Value: |
Cycle Delay |
| (Off) |
Defrost |
|
|
Termination Temp | edit | reset |
Compressor Shift
Delay On/Off
back
Figure 13. Modify communicating device settings
Figure 12. Accessing communicating device settings
With one of the devices highlighted, press about, then use arrow keys to see a list of data about the selected device. If you select reset ALL, and then confirm, ALL devices will be reset to their factory settings. (You would see a screen similar to figure 14.)
With one of the devices in figure 12 highlighted, press edit to go to that device’s list of settings (see figure 13).
Use the up/down arrows to scroll through the device’s settings and ob- serve the right hand side of the screen (figure 13) to see the current set- ting, for example, Current Value: (Off). Press edit if you want to modify that setting, or press back to return to the previous screen.
Settings available for the devices are dependant on the components you have. Shown below is an example of changing the compressor shift delay on. After using the arrows to select On, press save to save the changes and return to the previous screen.
Compressor Shift Delay On/Off
On
Offcancel
save
506052−01 11/09 | Page 10 |