Lennox International Inc Touch Screen Programmable Communicating Thermostat Setting time and date

Installer setup − Page 3 of 8

Setting time and date			S	Press other boxes and adjust with the arrows for all time and date
Use the arrows to select Time and Date; press edit (see figure 7). Press				information. When the date and time is correct, press save to save
				settings and return to previous settings screen.
next to proceed to the ).
setup	tests		HELP	setup		HELP
system settings	to adjust a setting, highlight				Time and Date
	it, then press edit.
Time and Date		Current Value:
Daylight Saving
	(September 15, 2009,
Time
		09:23 AM)			:19	AM
				10
Circulate Fan ON
						adjust
time
				Oct	15	2009
	edit
Dealer Name
						cancel
Dealer Address
Dealer Phone
Number						save
	back		next step
Dealer Email

Figure 7. View/edit time and date

When the Time and Date" screen appears, enter the correct date as fol- lows:

SPress one of the time and date boxes − the text will change to white type in a dark box (for example, press the ).

SPress the up/down arrows to change the data.

Figure 8. Set current time and date

NOTE − After setting the time and date, if you don’t need to add any non− communicating devices, you may wish to accept the default system pa-

rameters and skip forward to o do so, repeatedly press next step on each screen until you get to the tests screen. From there, you can check the systems operation. Thereafter, should you need to change a communicating device parameter, access those settings by pressing the equipment tab in the installer section.

506052−01 11/09 Page 8