Samsung AR30JVFUCWKNMG manual Fixing the indoor unit in place, Fixing the outdoor unit in place

Fixing the indoor unit in place

Perform the following work on the area where gas leak test was done priorly.
After checking for gas leaks in the system, insulate the pipe, hose and cables.		Insulation
Then place the indoor unit on the installation plate.
1.	To avoid condensation problems, wrap foam insulation (as shown in the figure) on
	a part without insulation on the end of the pipes.
2.	Wind the pipe, assembly cable and drain hose with vinyl tape.	Pipes
3.	Place the bundle (the pipe, assembly cable and drain hose) in the lower part
	of the indoor unit carefully so it does not project from the rear of the indoor	Installation
	unit.
4.	Hook the indoor unit to the installation plate and move the unit to the right	plate	Connecting
		Vinyl tape	pipes
	and left until it is securely in place.
		Connecting wires
	• Make sure pipe does not move when you install the indoor unit on	Drain hose
	an installation plate.

5.Wrap the rest of the pipe with vinyl tape.

6.Attach the pipe to the wall using clamps (optional).

ENGLISH

Fixing the outdoor unit in place

Install the outdoor unit in level on a stable base to avoid the generation of noise and vibration, especially when installing the unit close to a neighbor.

If you install the outdoor unit in a place exposed to strong winds or at a height, fix it to an appropriate support (wall or ground).

1.Place the outdoor unit as indicated on the top of the unit to let the discharged air out properly.

2.Fix the outdoor unit in level to an appropriate support using anchor bolts.

3.If the outdoor unit is exposed to strong winds, install shield plates around the outdoor unit so that the fan can operate correctly.

'403' mm

'690' mm

Rubber leg

• Secure the rubber leg to prevent the generation of noise and vibration.

Outdoor unit installed on the wall by rack

• Ensure the wall will be able to suspend the weight of rack and outdoor unit;

• Install the rack close to the column as much as possible;

• Install proper grommet in order to reduce noise and residual vibration transferred by outdoor unit towards wall.

Designed to cut off residual vibration from outdoor unit to rack.

(not supplied with product)

Soft rubber designed to cut off vibration from rack to wall. (not supplied with product)

English-43

MAX4 AR30JV&JS_IB&IM_DB68-04541A_EN.indd 43

2014/9/26 16:39:04