AMPLIFIER APPLICATIONS
PAB 4100 4-Channel Amplifier
2 way active, or bi-amplified system with mono bass
This application shows how easily a 2 way active system can be imp- lemented using a Premium 4 channel amplifier. Channels 1 and 2 will be used for highs, and channels 3 and 4 for mono bass.
Interconnect cable checklist:
We need to feed the same signal to both sets of channels, so must use 2
Mono bass woofer wiring:
Connect the mono speaker positive terminal to the LEFT +, and its negative terminal to RIGHT
Switch setting checklist:
-1/2CH
-3/4CH
Crossover frequency control checklist:
Channels 1/2: | Channels 3/4: |
- HI PASS: 100 Hz | - HI PASS (subsonic): 20 Hz |
- LOW PASS: N/A | - LOW PASS: 100 Hz |
Please note that these frequency points are suggestions only. Refer to the loudspeaker manufacturer specifications and the section “Setting up systems after installation for best performance”
Level control checklist:
Refer to the section “Setting up systems after installation for best performance”
Minimum final loudspeaker impedances:
-2 ohm per channel in stereo mode
-4 ohm mono bridged
English
2 way active, or
Here we present a variation of the previous system. Since this is a 2 way system, we can use the front outputs from a head unit to drive the highs, and the rear output to drive the bass This method allows the listener to easily adjust the relative levels of bass to highs, with the front to rear fade on the head unit.
Channels 1 and 2 will be used for highs, and channels 3 and 4 for mono bass.
Interconnect cable checklist:
-Use good quality RCA leads to connect the inputs of the amplifier to the source as shown.
-Follow the instructions as per the previous system for switch and crossover settings.
9