12 Electrical Information
A. Wiring Requirements
NOTICE: This appliance must be electrically wired and grounded in accordance with local codes or, in the absence of local codes, with National Electric Code ANSI/NFPA
Code CSA C22.1.
•Wire the appliance junction box to
•A
•Low voltage and 110 VAC voltage cannot be shared within the same wall box.
WARNING! Risk of Shock or Explosion! DO NOT wire 110V to the valve or to the appliance wall switch. Incorrect wiring will damage controls.
B. IntelliFire PlusTM Ignition System Wiring
•Wire the appliance junction box to 110 VAC for proper operation of the appliance.
WARNING! Risk of Shock or Explosion! DO NOT wire IPI controlled appliance junction box to a switched circuit. Incorrect wiring will override IPI safety lockout.
•Refer to Figure 12.1, IPI Wiring Diagram.
•This appliance is equipped with an IntelliFire PlusTM control valve which operates on a 6 volt system.
•Plug the 6 volt transformer plug into the appliance junction box to supply power to the unit OR install 4 AA cell batteries (not included) into the battery pack before use.
C. Optional Accessories Requirements
•This appliance may be used with a wall switch, wall mounted thermostat and/or a remote control.
Wiring for optional Hearth & Home Technologies approved accessories should be done now to avoid reconstruction. Follow instructions that come with those accessories.
•Hearth & Home Technologies recommends that Intel- liFire PlusTM wireless controls be used for their features and functionality with the IntelliFire PlusTM ignition sys- tem.
|
| FLAME | IGNITOR |
|
|
|
|
|
|
| SENSE |
|
|
|
|
|
|
TO JUNCTION |
|
|
|
|
|
|
|
|
BOX (110V) |
|
|
|
|
|
|
|
|
| MODULE |
|
|
|
|
|
| |
| FLAME |
|
|
|
|
|
|
|
| MODULATION |
|
|
|
|
| RC100 | RC200 |
|
|
|
|
|
|
| ||
|
|
|
|
|
| (OPTIONAL WALL CONTROLS) | ||
ORANGE | GREEN |
|
|
| BATTERY PACK |
|
|
|
(PILOT) | (MAIN) |
|
|
|
|
|
| |
|
|
| 6V DC |
|
|
| ||
|
| BLACK |
|
|
|
|
| |
|
|
|
|
|
|
|
| |
|
| RED |
|
|
| THERMOSTAT WIRE |
| |
|
|
|
|
|
|
| ||
|
|
|
|
|
|
| ASSEMBLY / WALL |
|
| BROWN |
|
|
|
| SWITCH WIRE |
| |
|
| GROUND |
|
|
|
|
|
|
Figure 12.1 IPI Wiring Diagram |
|
|
|
|
|
|
| |
| Heatilator | • | • | • | 11/11 | 51 | ||