Napco Security Technologies GEM-P3200 Direct Address Program Mode, Direct Address Overview

WI818G 10/05 Page 15

DIRECT ADDRESS PROGRAM MODE

DIRECT ADDRESS OVERVIEW

Direct Address Programming allows you to go directly to the address locations (up to 4095) and change the data entries manually in order to customize your control panel options. Whereas the Easy Menu Program Mode guides you through limited selections to get you started, Direct Address Program Mode allows you to change all options directly. It con- sists of up to 4095 address locations each with data entry locations as shown in the following diagram (below left). The data entry location accepts data in one of three formats: Binary, Decimal and Hexadecimal (explained below in "Address Mode Displays"). The following diagram (below right) illustrates a Decimal format data entry location (using a GEM-RP1CAe2/GEM-K1CA keypad).

ADDRESS

LOCATIONS

0000

0000

TO

4095

DATA ENTRY

LOCATION

DATA ENTRY LOCATION:

(One of three formats):

•Binary (Bit)

•Decimal

•Hexadecimal

GEM-RP1CAe2/GEM-K1CA Keypad Display Example

0 0 0 0 0 6 0 D

= ADDRESS LOCATION

= DATA ENTRY LOCATION

DIRECT ADDRESS

ADDRESS MODE DISPLAYS

There are three types of address displays when programming in Direct Entry Program Mode, as follows:

A) Binary (Bit) Format

Settings (such as Zone Features) display and accept data in "number" format. For example, Zone Features are turned on by the pressing of keypad buttons 1 through 8, with the activated Zone(s) displaying the corresponding decimal digit (replacing deactivated zones which are signified by dashes).

EXAMPLE: BIT Format with the GEM-RP1CAe2/GEM-K1CA: Program Zones 2, 4, 5 and 7 as Exit/Entry Fol- lower Zones.

PROGRAM MODE

1218 - - - - - - - - B

Address	DATA ENTRY LOCATION:
1218	Binary (Bit) Format
"Exit/Entry	• No zones yet activated
Follower"

DETERMINE THE DATA ENTRIES

1218 - 2 - 4 5 - 7 - B

Address	DATA ENTRY LOCATION:
1218	Binary (Bit) Format
"Exit/Entry	Press 245and 7in
Follower"	order to activate Zones 2, 4, 5, and 7. (The "B"
	on the right indicates "Binary" format).

Referring to ZONE FEATURES in the Programming Worksheets that follow, the Exit/Entry Follower for Zones 1 through 8 are located at address 1218.

LNAPCO Security Systems XGEM-P3200 Programming Instructions