Napco Security Technologies GEM-P3200 ACM Zone Options Address 2740, ACM Global Flags Address

OPTIONS

Page 38 WI818G 10/05

ACM ZONE OPTIONS (ADDRESS 2740 - 2769)

ACM ZONE OPTIONS:

Enter the Zone numbers (in decimal 1-48 format) for each option in the table below. Press Uor Dto save.

NOTE: Dark shaded data value box shows option not available. Note: The Area # for Door 1 is controlled by the ex- isting Keypad Programming table (Address 2425 to 2431). The assigned area for Door #2 for each ACM must be en- tered in the table below (addresses 2748 and 2758) and must not be left blank if Door 2 is to be used.

ACM1 Zone Options	ADDR	Door 1	ADDR	Door 2
Door Contact	2740		2745
Forced Entry Zone	2741		2746
Door Ajar Zone	2742		2747
Area # for Door 2			2748
Reserved	2743		2749
Reserved	2744
ACM2 Zone Options	ADDR	Door 1	ADDR	Door 2
Door Contact	2750		2755
Forced Entry Zone	2751		2756
Door Ajar Zone	2752		2757
Area # for Door 2			2758
Reserved	2753		2759
Reserved	2754

ACM GLOBAL FLAGS (ADDRESS 2780)

ACM

2780	ACM Global Flags
Default			Option
OFF		1	Enable Two-Swipe Arming
OFF		2	Enable NAPCO Proprietary Access Format
OFF		3	Enable Facility Code
OFF		4	Enable Access Logging into Burg Log
OFF		5	Enable Printing of Access Events
OFF		6	Enable Card Presentation Beep and Green LED Flash
OFF		7	RESERVED
OFF		8	RESERVED

ACM GLOBAL FLAGS:

1.Select the desired option entering the option number (1-8) for each digit.

2.Enter corresponding option number in address loca-

tion.

NOTE: Dark shaded data value box shows option not available. Press Uor Dto save.

		ACM TIMEOUTS (ADDRESS 2782 - 2783)
Maximum	ADDRESS 2782			ADDRESS 2783
Two-Swipe			Unlock Time
Arm Time			(sec.)
(x100ms)
[Default = 030 = 3 seconds.]			[Default = 005 = 5 sec.]

Enable ACM Access (address 2423) must be enabled.

Address 2782 determines the maximum time allowed for the double swipe (x100ms). Address 2783 determines the door unlock time, in seconds, after a successful entry.

1.Select timeout (1-255).

2.Enter in corresponding address locations above and right. Press Uor Dto save.

XGEM-P3200 Programming Instructions LNAPCO Security Systems