
THIS MANUAL INCLUDES FEATURES WHICH ARE ONLY AVAILABLE IN CONTROL PANEL FIRMWARE VERSION 50 OR LATER.
IMPORTANT NOTE
This manual supports the keypad programming of the
Program Mode is the same for both
•The Abutton and the Rbutton operate identically (in Program Mode) for both keypads.
•The Dbutton and the Ubutton operate identically (in Program Mode) for both keypads.
•The button and the
button operate identically (in Program Mode) for both keypads. The words "NEXT/YES button" are used in this manual.
•The button and the
button operate identically (in Program Mode) for both keypads. The words "PRIOR/NO button" are used in this manual.
For consistency, it is recommended that all keypads either be all "classic" or all "K
CHANGES FROM PREVIOUS EDITION
The following changes have been made to this manual (WI818G) since the previous edition (WI818F).
New addresses added to accommodate the
•Enable ACM Access
•ACM Zone Options
•ACM Global Flags
•ACM Timeouts
•ACM Door Area Options
•ACM Scheduled Free Access
•Enable Panel Options
•Emergency Free Access
•Keypad Home Area / ACM Door #1 Area (Hex)
•Addition to the Easy Program Menu instructions, "Enter Proximity Card Users".
Existing addresses were changed and new addresses were added to accommodate the NAPCO NetLink™
•For each telephone number desired, enable "Report to TCP/IP Receiver or AES" for Telco 1, Telco 2 and Telco 3.
•Enable "Callback Telephone No. Select". Enter either "1" for Callback Telephone Number 1 or "2" for Callback Telephone Number 2.
•Enable "Handshake for Local Telemetry"
•Enable "TCP/IP Communications"
•Enable "TCP/IP Panel/Site Initiated Functions"
NAPCO Security Group, Inc.,
333 Bayview Avenue, Amityville, New York 11701 For Sales and Repairs, call toll free: (800)
For direct line to Technical Service, call toll free: (800)
Internet: http://www.napcosecurity.com