Napco Security Technologies GEM-P3200 quick start Address Program Mode, 2406, Direct, Zones

Page 16 WI818G 10/05

ADDRESS PROGRAM MODE

				ZONES 1			8						ZONES 9			16
ZONE FEATURES	ADDR	Z1	Z2	Z3	Z4	Z5	Z6	Z7	Z8	ADDR	Z9	Z10	Z11	Z12	Z13	Z14	Z15	Z16
		1	2	3	4	5	6	7	8		1	2	3	4	5	6	7	8
Exit/Entry Follower	1218						6	7	8	1318

PROGRAM THE DATA ENTRIES

1.Enter the panel's Dealer Security Code, then press R.

2.Answer NO to all questions until “ACTIVATE PROGRAM Y/N” is displayed; then press YES. NOTE: If you pass “ACTIVATE PROGRAM”, scroll backward using B.

3.Press Cto enter the Address Program Mode. Address "0000" will display.

4.Press 1218to access Address 1218. The existing data will display and the cursor will advance to the data field.

5.Press 678. The numbers 6,7 and 8 will appear on the keypad display indicating the zones activated.

6.Press Uto save. Address 1218 is now programmed with “6,7,8”.

7.Press Rand enter another 4-digit address to continue programming--or--press Cto exit and resume normal keypad operation.

B)Decimal Format

Settings (such as Entry and Exit Delay) display and accept data in decimal format, as a 3 digit number. Data is en- tered directly, by pressing keys 0 – 9, with the cursor automatically moving to the right upon each key press.

EXAMPLE: DECIMAL Format with the GEM-RP1CAe2/GEM-K1CA: Program Abort Delay to be 15 seconds.

2406 - - - D 2406 015 D

DIRECT

Address	DATA ENTRY LOCATION:
2406	Decimal Format
"Abort	• No time yet entered
Delay"

DETERMINE THE DATA ENTRIES

Address

2406

"Abort

Delay"

DATA ENTRY LOCATION:

Decimal Format

Press 015in order to set

"Abort Delay" to 15 seconds. The "D" on the right indicates "Decimal" format.

Referring to SYSTEM DELAYS & TIMEOUTS in the Programming Worksheets that follow, the Abort Delay is lo- cated at address 2406:

ABORT ADDRESS 2406

DELAY

(sec.)

[Default = 000]

PROGRAM THE DATA ENTRIES

1.Enter the panel's Dealer Security Code, then press R.

2.Answer NO to all questions until “ACTIVATE PROGRAM Y/N” is displayed; then press YES. NOTE: If you pass “ACTIVATE PROGRAM”, scroll backward using B.

3.Press Cto enter the Address Program Mode. Address "0000" will display.

4.Press 2406to access Address 2406. The existing data will display and the cursor will

XGEM-P3200 Programming Instructions LNAPCO Security Systems