Honeywell K5305-1V5 setup guide System Security Codes, Attributes Values, Level User No Functions

Installation and Setup Guide

System Security Codes

The systems provides one Installer code, one System Master code, plus a set of other user codes intended for other users of the system. These codes can each be assigned one of 5 authority levels, which determine the functions each code can perform as listed in the table below.

VISTA-20P: Provides 48 security codes (plus Installer code), including one System Master code, two Partition Master codes, and 45 general user codes.

VISTA-15P: Provides 32 security codes (plus Installer code), including one System Master code and 31 general user codes.

Authority Levels (can be assigned to users 03-49 only; users 1 and 2 cannot be changed)

Level	User No.	Functions
Installer	01	(default=4112) perform all security functions except can disarm only if used to arm; can
		enter program mode; can change System Master code; cannot assign any other user
		codes
System	02	(default 1234) only one system master code per system; can perform all security
Master		functions, add/delete users in either partition, change system master code, view event
		log, set system clock, program keypad macro, program scheduled events, activate output
		devices (triggers/relays)
Partition	P1 = 03	VISTA-20P. Same as Master, except add/delete users limited to assigned partition
Master	P2 = 33	only, (these users can be assigned different authority levels, if desired; any user can be
(default)		assigned the partition master authority level)
0-User	03-49 (V20P)	perform security functions (arm, disarm, etc.) only; cannot add/delete users, view event
	03-33 (V15P)	log, set system clock or program scheduled events
1-Arm Only	see “user”	arm system only
2-Guest	see “user”	can disarm the system only if it was used to arm the system
3-Duress	see “user”	performs security functions, but also silently sends a duress message to the central
		station; reports as duress code user number.
4-Partition	see “user”	VISTA-20P. See Partition Master paragraph above; used to assign other user numbers
Master		as partition masters

Refer to the user guide for detailed procedures on adding/deleting security codes and changing user attributes.

The following is a brief description of how to add user codes. Changing the System Master code...

Using Installer code: Installer code + [8] + 02 + new code

Using current System Master code: System Master code + [8] + 02 + new code + new code again Adding a User Code: Master code + [8] + 2-digit user no. + user’s code

Deleting a User Code: Master code + [8] + 2-digit user no. + [#] [0]

Assigning Attributes: Master code + [8] + 2-digit user no. + [#] [attribute no.] + value

Attributes:		Values
1 =	Authority Level	0-4 (see Authority Level table above)
2 =	Access Group	0-8 (0 = not assigned to a group)
3 =	Active Partition(s)	1, 2, 3 (common)
	for this user;	Enter partitions consecutively if more than one and press [#] to
		end the entries.
4 = RF Zone No.		Assigns user number to button type zone for arm/disarm
		(keyfob must be enrolled in system first; see Wireless Key
		Templates section).
5 =	Open/Close Paging	1 for yes, 0 for no

6-4