Linear DUAL 824 manual Basic Control Panel Programming, Create the Master User Code

7.BASIC CONTROL PANEL PROGRAMMING

✦In a new installation, when power is first applied the system's master user code is “1234”.

CREATE THE MASTER USER CODE

✎NOTE: Local programming must be entered on the system's hardwired keypad, not on a wireless keypad.

1.Press (clears keypad if any other keys have been pressed).

2.Place the system in Test Mode (enter 1234 and press TEST.

✴A “gong” and four “beeps” will sound.

3.Enter the Setup Mode from Test Mode, enter 1234 then press TEST again.

✴A “gong” and fi ve “beeps” will sound. The system is now in Test Mode.

4.Enter 99 then press HOME.

5.Enter any combination of 1-5 digits for the master user code, then press AWAY.

✎NOTE: For maximum security, a three to five digit code is recommended.

6.Press and hold the OFF key for 3 seconds to exit program mode.

7.Test the new master user code by entering it then pressing TEST.

8.Log the master user code in the box below.

MASTER USER CODE:

✎NOTE: The master user code can be used to enter Setup Mode. The restricted user codes cannot. To create restricted user codes, see the “Advanced Programming” section of this manual.

ENTERING

SETUP

MODE

START IN OFF MODE

CLEARS

KEYPAD

DEFAULT

MASTER

USER

CODE

1 GONG &

4 BEEPS (TEST MODE)

DEFAULT

MASTER

USER

CODE

1 GONG &

5 BEEPS (SETUP MODE)

SETTING A

NEW MASTER

USER CODE

START IN SETUP MODE

PROGRAMMING

STEP #99

ENTERS STEP

NUMBER

NEW

MASTER

USER

CODE

STORES

NEW CODE

HOLD FOR

3 SECONDS TO EXIT

DONE SETUP

14